Tikka bell and carlson stock

Anyone know a possible sweet spot for the
Action screw Torque spec on the above stock an tikka action? Maybe some has had a play in the past and
Found something that works the best? I have a torque driver now, but last time I just used the fitters feel, and guesstamation theory.

Cheers Magnus

Quote:

---

Originally Posted by Magnus

Anyone know a possible sweet spot for the
Action screw Torque spec on the above stick an tikka action? Maybe some has had a play in the past and
Found something that works the best? I have a torque driver now, but last time I just used the fitters feel, and guesstamation theory.

Cheers Magnus

---

This is what Weatherby advise for there stocks, this is what I use for my mk v composite stock with bedding block.
They list different values for wood, carbon, composite and synthetic, I imagine Tikka would be similar.

https://faq.weatherby.com/torque-procedures

Cheers Danny I'll have a gander.

I've got mine torqued yo 50in/lbs

I'd use tikkas factory specs and check for accuracy as your still screwing against their less than ideal bottom metal which fails if over torqued, unless you have swapped out the triggergaurd/btm metal?

I would look up what B&C say. I put a B&C stock on a mates T3 last year and it transformed it. They still need a skim bed on the Ali bedding block. So relieve the Ali block and wrap tape around the barrel to centralise the fore-end first.

Quote:

---

Originally Posted by Kelton

I'd use tikkas factory specs and check for accuracy as your still screwing against their less than ideal bottom metal which fails if over torqued, unless you have swapped out the triggergaurd/btm metal?

---

Yea I've put a Hardy bottom metal in it.

Quote:

---

Originally Posted by Moa Hunter

I would look up what B&C say. I put a B&C stock on a mates T3 last year and it transformed it. They still need a skim bed on the Ali bedding block. So relieve the Ali block and wrap tape around the barrel to centralise the fore-end first.

---

Yea I'll look into bedding the action and the alloy block, but want to see any gains over a straight swap with the factory stock first

My Tikka manual says 44 inch pound for plastic trigger guard and 62 inch pounds for metal trigger guard.

Say it with me

INCH pounds :D

Attachment 220278

Quote:

---

Originally Posted by Rated M for Magnum

My Tikka manual says 44 inch pound for plastic trigger guard and 62 inch pounds for metal trigger guard.

Say it with me

INCH pounds :D

---

You only make that mistake once :yaeh am not durnk:

Quote:

---

Originally Posted by Rated M for Magnum

Say it with me

INCH pounds :D

Attachment 220278

---

Yes Sir "inch pounds"

I do recall though that my Sako a7 rough tech was 30 inch pounds with a plastic trigger guard...I'd say if you wanted to experiment, start at the Tikka recommended and work down looser. Just my 2 cents.

Cheers, I might start at 50 and work up in 2 inch pound incriments an see what happens.

Quote:

---

Originally Posted by Magnus

Cheers, I might start at 50 and work up in 2 inch pound incriments an see what happens.

---

Is your trigger guard/ bottom metal made of metal or plastic ? If its plastic 50 inch pounds may be too much

Yea it's a Hardy alloy bottom metal @dannyb