Thread: Torch mounting options?

Hey guys I have a new Maxtoch to go on my 10/22 as a walking spotlight and was wondering what mounts people were using. Have a few but they don't hold the torch high enough above the scope. Any ideas?


Sent from my iPhone using Tapatalk

Scope mount.

Tried this.



Not I use these on the scope, and a tall scope mount ring on the torch Wholesale Product Snapshot Product name is 1"&30mm 25mm Ring 20mm Weaver Rail Mount with Adapter For Torch Flashlight Laser Scope Sight Hunting

Got one of those velcro/rubber dealies for the P7, about $26. A bit cheap and nasty but works ok.

I used a clamp type on the scope but got a bit of glare reflecting back from the can. I tried a few mounts then thought bugger it, In the end i got my joiner mate to machine a flat on the bottom of my 17s stock and bolted a picatinney rail to it.
Torch was 25mm so a shitty scope mount i had lieing around did the job nicely. Now I know not everyone will like it but it works for me.

Sent from my GT-I9001 using Tapatalk 2

I use what Kscott posted and a high ring to clear the scope.. all from Aliexpress so didn't cost much at all...

Yeah this is my current setup just with what I had. Works but not ideal.


Sent from my iPhone using Tapatalk

Just got those bits off tardme for about $40. Wanting for the weekend though so no Ali. Cheers guys


Sent from my iPhone using Tapatalk

It's on there so that's a good start.. these are the links to what I bought...

2 x High Profile See Through 25.4mm Scope Rings 21mm Picatinny Weaver Rail Mount Free Shipping-in Scope Mounts & Accessories from Sports & Entertainment on Aliexpress.com | Alibaba Group

Free Shipping Tactical Hunting 25.4mm & 1'' Rifle Scope Ring Mount 20mm Rail For Rifle Additionl Flashlight Laser-in Scope Mounts & Accessories from Sports & Entertainment on Aliexpress.com | Alibaba Group

Tactical 1 Pair 25.4mm Diameter See through Rifle Scope Weaver Ring Mount Picatinny 20mm Rail For Hunting-in Scope Mounts & Accessories from Sports & Entertainment on Aliexpress.com | Alibaba Group

I had the mid mount which was fine with a 4x32 scope, but needed the high with the 3-9x40.

+1 GMH/KScotts suggestion - does the job perfectly. The tall rings mounted onto the wee picatinny rail allow M24 to clear scope bell well. Quick on/off too.

If you get glare off your can the easiest option is to mount the torch further back so that the suppressor is in the shadow of the scope bell.

why not under the barrel, works great for me and easier to turn off and on with your left hand.

this is the quickest and easiest i have found

I made the barrel - standard 10/22 barrel with a Maniatis suppressor, then turned down part of the barrel to allow an alloy shroud to slip over it.
Very quiet, and the torch slung underneath gives me no scope glare.
Torch is a Convoy C8 XML2 with a smooth reflector.