Cambo do the spitlights still jeed to be hooked to a seoerate switch or can they just run off the high beams?
Printable View
Cambo do the spitlights still jeed to be hooked to a seoerate switch or can they just run off the high beams?
So long as they can be switched from the drivers position - technically means they can be hooked up straight to the Hi beam.
But better to fit a separate switch I reckon.
Yeah if you have them hooked up to the high beams then have an override switch that'd be enough to keep everyone happy right?Quote:
Originally Posted by cambo
I intended to do that originally but was in a rush.
Yeah that's the better way to do it RNZ, but not necessary to pass a WoF.
Nice LEDs out as well but expensive, by law do you have to have extra spots hooked to the dip? Cannot run on a separate switch.
RF will be ok with a relay inline
A relay is a must with any add on light. Stops the h/l switch and wiring burning out due to excessive currant draw.
For WoF's, spotties must have a light beam angle of 0% (0mm drop over 3m). The same as the Hi beam setting.
There's no rule for how to wire them in regarding a separate switch, but it is highly recommended.
So long as the spot lights can be turned off/on from the drivers seated position you are able to wire them in however you like to the main beam (Hi-beam)
Hey Cambo we just use the high beam switch wire to activate a relay that runs the spots straight from the battery. Wont burn anything out that way.Quote:
Originally Posted by cambo
You're all good there RNZ. :thumbsup:
So can you get a WOF with HID driving lights with switch on them as well as being wired so they only go on hi beam ? Have some I will be fitting ?Quote:
Originally Posted by cambo
Yup that's right Happy.