There is a couple of hulls around, but fecked if I can find them again
Anyone know who makes them?
There was one in Wanganui and also a poly one built down south - anymore?
There is a couple of hulls around, but fecked if I can find them again
Anyone know who makes them?
There was one in Wanganui and also a poly one built down south - anymore?
Dink Dawson in Whakatane,Dawson Furs, blowmolded poly
Tuffjets go where no boat has gone B4!
Last edited by madjon_; 25-10-2013 at 12:49 PM.
Real guns start with the number 3 or bigger and make two holes, one in and one out
GoPro Jetboat sinks again! - YouTube
Send this guy a message...
Haven't seen the Tufjets before... Look good but not cheap!
There is another poly one out there too
Marine and General Engineering here in Nelson build em how you want from Hull only to Trun Key and all points in between..
Trust the dog.........................................ALWAYS Trust the dog!!
ive been researching this lately also, thought about doing it on the real cheap, using a dingy, change the bottom to thicker aluminium and wack a jet ski motor and jet unit into it, also thought about buying a complete jet boat but a older one as a donor boat and buying a fresh hull, but they want an arm and a leg for them
Hmm would my 3.8 Commy V6 and single stage unit fit in one of those .. I think not.. Bugger..
I reckon one of those Tuff Jets would be awesome round here .Hit the river then stop at Thames !!
Off course after several fuel and beer stops en route through the towns..
What were the Tuff jets 15k or so.. Ouch ..
"This is my Flag... Ill only have the one ..
These boats are without a doubt the best way to go, goat and his mates have them sorted, CRR900RR motors and jet ski pumps.
Get in touch with them for test rides and they will help you to the finished product, then the fun begins.
They are on a nz jetboat.com forum
Here is the build video
http://youtu.be/3yzwpWmbPDM
ZX 10 power
http://youtu.be/iNTTJQk45qw
A big fast bullet beats a little fast bullet every time
nzjetboating.com The home of JBNZ Online. Check out the forum under projects, etc
Shut up, get out & start pushing!
I really want a finished bare hull to bolt engine into and fit out.
10ft alloy hull would be about spot on
have a look at this spanners,
Jet Boat | Trade Me
fussy bugger, how about this one ALUMINIUM JET BOAT HULL 10 ft | Trade Me
Bookmarks