Thread: Small Honda motors

Does anybody on here sell small Honda motors or know who does at good prices?
I'm looking for a 13.5 hp to run a hydraulic pump for a woolpress.
Kyle

I run the Titan branded Honda copies from a place in motueka, have never had a problem with them, unlike some of the .

They're listed on trademe

@specweapon
What application do you use the titans for? I think I found him on trademe. Also sells genuine Hondas.

A couple of pumps, a mobile air compressor and have replaced a few logsplitter motors for mates, and a 7.5hp one with centrifugal clutch on the kids go kart

You need a 13.5 HP?

I see that don't actually do a 13.5 anymore. It's a 11.7hp now.
Our thinking is 8hp will be marginal and the 13.5 will be ample.
Needs to run a hydraulic pump at 45l/min and iirc 3,000 psi but I'll check my notes
It's 3200 psi with a 3 stage pump

Originally Posted by puku

I see that don't actually do a 13.5 anymore. It's a 11.7hp now.
Our thinking is 8hp will be marginal and the 13.5 will be ample.
Needs to run a hydraulic pump at 45l/min and iirc 3,000 psi but I'll check my notes
It's 3200 psi with a 3 stage pump

Shit it must be one hell of a wool press mate


Sent from my iPad using Tapatalk

Does the whole sheet cans the meat and separates the wool! Puku I'll check tomorrow I have one but need to refresh my memory

Originally Posted by BRADS

Shit it must be one hell of a wool press mate


Sent from my iPad using Tapatalk

Nah that's just standard pressure for no tramp presses.
The press is an old lyco 25+ yrs and has done the clutch. As they are no longer made and the clutches were the weak link there's no chance of getting a replacement.
So looking at getting a portable power pack. Main problem is our power supply into the shed low, around 215 volts.