Will someone please tell me how the protected version of these differs from the unprotected and what are they protecting thanks Huk
Printable View
Will someone please tell me how the protected version of these differs from the unprotected and what are they protecting thanks Huk
The protection circuit usually protects from over current, over voltage and under voltage states. Some will do over temperature as well.
whats the petrol method? wouldn't turps work better?
Yeah apparently these puppies can overheat and explode or at least burn... ?? The protection is a little chip which monitors the battery and prevents such an event. The protected ones are a little bit longer - because of the chip. Apparently you can cut it off and use it without but why would you?Quote:
Originally Posted by Huk
It is very, very rare for name brand 18650's to explode (they wont simply burn though!).
Even the best PCBs can suck 10% or more of the battery life, current and voltage but its worth it if you run a heap of batteries in series, run them in reverse in an unprotected light, or just plain misuse them.
http://i70.photobucket.com/albums/i1...pszk9xzo1d.png
Chris
Thanks for the replys guys have both for my torch but wasnt sure about using the unprotected ones in it but sounds like should be ok
The general rule is only use protected cells in multi cell torches to avoid over discharge.
The one application unprotected cells are recommended to be used is in a dive torch.
I have been frustrated with the cheap trustfire/ultrafire batteries not behaving. where is the best place to get the panasonics?
That's a good price crnkin posted from Fasttech. These are slightly more expensive, but they'll probably ship faster. I've bought heaps of stuff from this seller (name is Simon) and the average time to arrive at my door from the time of order is about 10 days
I got some from Batteryworx in Onehunga. They repack power tool batteries. The batteries have no brand on them but the guy reckoned they are as good as you can get (reckoned there was no point in using anything else as the labour cost of re packing is 90% of the cost). They last as long as the NCR ones I got, and we're only $6 each. They are flat top, but I just siliconed a copper washer on one.
That sounds dodgy as all balls.
Are there any markings on the batteries at all? Do you have a pic of them? Might be re wrapped tho I spose.
Chris
Batteries are plain blue with a sticker saying "7.4 wh 800 cycle times". Don't thinks there's anything dodgy about them, he's been repacking power tool batteries for years so must be doing something right. Wouldn't imagine he'd still be in business if he was using crap batteries.
@Grotto Simpower in Auckland do exactly the same thing, repack. Had a battery drill battery done. They increased the capacity over the original as well and it cost less than a new battery. Also bought a replacement laptop battery and cell phone batteries off them. They also don't use/sell crap batteries. In the case of my drill they were Sony cells.Quote:
Originally Posted by Grotto
That means they are 2000 mAH @ 3.7 v nominal.Quote:
Originally Posted by Grotto
That will be at .5 or 1 Amp whereas a typical light will draw 3amps.
Honestly man, you run the risk of blowing your hand off, or worse. Its just not worth it using unbranded cells.
Chris
Problem is you have no idea how much use those batteries have had.. They may be cheaper than brand new Panasonic 3400's but the won't be as high capacity and they could be on their last legs...
Edit: just saw Chris' post. Basically what he said