Anyone here done it?have a Svord knife but not keen on the smooth wood handle once it gets a bit of blood on it gets real slippery ,have an old cast antler in the shed ,any tips or advice welcome.
Printable View
Anyone here done it?have a Svord knife but not keen on the smooth wood handle once it gets a bit of blood on it gets real slippery ,have an old cast antler in the shed ,any tips or advice welcome.
No expert but drill a hole down the middle of a tine, fill with epoxy resin and stick the tang in, bung it in a vice overnight then sand any excess away... Sure there are a few on here that are more knowledgeable. I do know that antler (fallow) is a prick to try and spin on the lathe as you always end up with a bit of marrow showing and it ruins the look
Mine is smooth but dosen't seem to get slippery.
https://image.ibb.co/cTzNUd/IMG_1711.jpg
Is that antler or wood?
It's polished antler.
I have done it on a couple of knives I made, antler is bloody tough stuff and stinks something aweful when you sand it!
You also need to keep it oiled after or it dry out and crack.
Micarta is another option that works in the wet, or G10.
Save the sanding dust and snort it, viagra effects! Well if your Asian?
you need a bit of antler that is nearly the right finished handle size already because the middle pith of the antler is too soft and you dont want to expose it. I use one of those thin angle grinder cut off disks to cut it ,then sand it. The dust is very bad for you so wear a mask. sambur antler is the best because it has a lot thicker outer layer than other types of antler.
@Brian nice one :)