Thread: Meindl Boot Failure !

I got a pair of Mindls from @Sarvo and they shit themselves.
I went through Stagers to get some resolution as the boots I brought were MINT. They re-glued soles twice.
I got ahold of Sarvo and kept him in the loop about what was going on. Because hes such a good bastard he replaced them with a pair of Han Wags. Thats customer service right there.

Sorry Paul, its really out of our hands, Most high end boots have Vibram soles and if they are not worn often the PU material of the sole unit created by Vibram does show a slow degradation over time when left in storage with no use. The boot is designed to be worn often. The walking motion pushes air through the structure and materials of the boot and sole. This fresh air movement dries the materials and staves off the degradation. Life spans of more than 10yrs are normal when the boots are worn regularly.
The number one worst thing to do with boots with PU and EVA sole units is to not wear them and leave them stored for ages after a couple of field uses. Water and humidity will be sitting inside the boot materials and structure for years slowly degrading the materials. The boots should be worn for minimum a few days per month and ideally once a week. These will need to be resoled as no point in gluing them again. This would have to be at your cost however. We can send them to the repairer should take about two weeks. Cost is $180.