If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed.
I recently scored a Kawasaki jetski hull off trade me for $1 (dumping the unwanted parts cost $30), it was a shit load harder than expected but I finaly managed to remove the top half and rear third, leaving me with this which is to be the hull of the boat, havent measured it but its around 2m.
I sold the yamaha 15h and scored a 4hp evinrude, This is a bit less grunt than I wanted but it just mean I can get him in it younger then upgrade later
The guy I bought it off said it pumped water sweet, I got it home and chucked it in a barrel of water and cranked it up, started fine but I wasnt convinced it was passing enough water. I shut it of and ended up rippin it to bits. Long story short the water jacket was chocker block with shit but there didnt appear to be any heat damage so I decided to throw a new seal kit and water pump impeller in and a good clean up.just gotta get the prop gear case filled and I'll spark her up again.
when you fill the leg with oil fill from the bottom plug until it comes out the top one heaps quicker. have you rang pete lately theres a few hares about.
Welcome to NZ Hunting and Shooting Forums! We see you're new here, or arn't logged in. Create an account, and Login for full access including our FREE BUY and SELL section Register NOW!!
Bookmarks