Thread: Ballistic apps

Originally Posted by mikee

so gave Applied Ballistic's another go.
Down loaded the custom drag curve for my current projectile of choice. Wacked in the range, velocity , temp, pressure etc then had 5 hits out of 5 attempts at 435m (5 inch plate) then dialed for 600m and went 3 for 3 on an 8 inch flasher plate.
The 130gn TMK projectiles seem much more consistently accurate past 500m compared to the hornady ELD-M 123's

My only gripe with that app is that you can't have multiple set ups like strelok.

Originally Posted by Russian 22.

My only gripe with that app is that you can't have multiple set ups like strelok.

Really? You can't have multiple rifles/loads?

Originally Posted by Russian 22.

My only gripe with that app is that you can't have multiple set ups like strelok.

If you are used to Strelok then Applied Ballistic's seems clunky to use

Originally Posted by Shearer

Really? You can't have multiple rifles/loads?

Not that I found. I found that you have to manually enter the info to change it.

Originally Posted by mikee

If you are used to Strelok then Applied Ballistic's seems clunky to use

Yes. I have used it because I have thought that it is more accurate as its a bushnell scope and bushnell app? Strelok is way more convenient now that I'll have 2 bushnell scopes on rifles.

Originally Posted by Russian 22.

My only gripe with that app is that you can't have multiple set ups like strelok.

Yes you can.
Multiple loads under one rifle even with offsets on current zero so the App will always tell you what to dial to hit target. Have three loads under my 223, two under the 6.5CM and two for my mates 270WSM.

Originally Posted by JaSa

Yes you can.
Multiple loads under one rifle even with offsets on current zero so the App will always tell you what to dial to hit target. Have three loads under my 223, two under the 6.5CM and two for my mates 270WSM.

Ah OK. I haven't found that possible.

How do you do it as I've played around with it and not found it yet.

Originally Posted by Russian 22.

Ah OK. I haven't found that possible. How do you do it as I've played around with it and not found it yet.

After you have entered your rifle and scope, tap on the rifle in the list. In the top right corner you will see a +. Tap this to add the bullet/load. You can do this multiple times and this is where you can set your offsets as well. Lets say you are zeroed in on load A but have another load B that shoots 1.5 high and 2.5 left. So make the according adjustments here and in the future the Applied Ballistics App will take this into account when displaying what to dial in.