I think my rings are optilocks with plastic inserts
I think my rings are optilocks with plastic inserts
When hunting think safety first
Those ones of mine are optilock without insert.
Just had a look and seems 25 inch pounds is the standard for ring cap screws on nf rings.
I certainly have never had any move.
When I am torquing them down make sure t keep going till there is no movement on the bit.
With my own rifles I always re check after the first zeroing session to make sure.
Sent from my SM-A226B using Tapatalk
My favorite sentences i like to hear are - I suppose so. and Send It!
Very nice work, @Larskramer !
My gun is 7mm08 w 140gr bullets and all up pretty much 4kg.
It holds zero but certainly doesn't shoot like those groups of yours.
I thought these were OK (screws finger tight only), but perhaps some attention to torque could be worth while.
This is at 100m with 1cm grid.
![]()
I also had a big ladder test to go through, my first ladder was groups of 3 looking for speed I was after ( anywhere close to 3000fps) and then SD spread in each group, hailed 64.2g with average 8fps spread. Then the seating depths were 0 jump, 5thou jump, 10thou jump, 20 and 30 with a 10 thou neck tension, then another repeat of jumps with a 20thou neck tension. Safe today she's a shooter!
Bookmarks