Thread: DIY Steel Plate Impact Detection

Hey mate, how about gluing it to the plate with urethane? look up the correct primers etc and it will never come off! should be flexible enough for a good pasting.
Even the plate could be urethaned to some brackets for hanging etc,
No bolts or chains or rubber to get shot up either.

Originally Posted by 40mm

Hey mate, how about gluing it to the plate with urethane? look up the correct primers etc and it will never come off! should be flexible enough for a good pasting.
Even the plate could be urethaned to some brackets for hanging etc,
No bolts or chains or rubber to get shot up either.

Thanks, Urethane not something I knew about. Will definitely read up on it and give it a go. Can you possibly recommend some brands and type of urethane glue to start off with?



Sent from my iPhone using Tapatalk

Originally Posted by janleroux

Thanks, Urethane not something I knew about. Will definitely read up on it and give it a go. Can you possibly recommend some brands and type of urethane glue to start off with?



Sent from my iPhone using Tapatalk

Sika or 3M are usually pretty good brands. Read up on the specs and instructions properly and you should be good.