Thread: DIY Steel Targets

If you let me know the sizes for the targets ie. diameter of target part. I can see how much some 6mm AR is and get my brother to cut out on water jet. Be cool to make one for myself as well

Originally Posted by McNotty

If you let me know the sizes for the targets ie. diameter of target part. I can see how much some 6mm AR is and get my brother to cut out on water jet. Be cool to make one for myself as well

6mm would be a bit thin for anything big I would think.

Originally Posted by Savage1

6mm would be a bit thin for anything big I would think.

My bad, didn’t read OP properly. Happy to get 10mm AR500. It’s not actually that expensive. $40 for a 300mm round AR500 gong through fletchers. Shouldn’t need a very big piece to cut all the targets from.

Originally Posted by McNotty

My bad, didn’t read OP properly. Happy to get 10mm AR500. It’s not actually that expensive. $40 for a 300mm round AR500 gong through fletchers. Shouldn’t need a very big piece to cut all the targets from.

Thats cheap for a 12 inch cut plate if that's correct I would be interested in some.

Originally Posted by Marty Henry

Thats cheap for a 12 inch cut plate if that's correct I would be interested in some.

This was August last year. I get a pretty sharp discount. @Marty Henry These are 12mm, they don't do 10mm in AR500 anymore, well they didn't at that time.
I did a heap for the forum a while ago but it was a nightmare sorting out pick ups. I'll get another quote for ya, you'll need to blow a hole with gas torch as they charge heaps just to cut a hole.