Welcome guest, is this your first visit? Create Account now to join.
  • Login:

Welcome to the NZ Hunting and Shooting Forums.

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed.

DPT Ammo Direct


User Tag List

Results 1 to 15 of 74
Like Tree44Likes

Thread: Little help needed

Threaded View

  1. #12
    Member Happy's Avatar
    Join Date
    Oct 2012
    Location
    Waikato
    Posts
    4,052
    So I have had this rifle since Saturday. Josh tells me hes only fired 9 rounds through it since owning it. Barrel was dirty but seen way worse.
    I found that the two fired shells supplied (once fired factory ammo) with it got tight when the neck area entered the barrel.
    So if you dropped the case in the hole it dropped in right up to the point where there was 5 to 8 mm that wouldn't go further unless you pushed the bolt real firmly.
    Needless to say the bolt was hard to open needed a light hit with rubber hammer to open it and eject the case. Visual inspection couldn't really see anything.
    Stripped it. Plugged the barrel pointing down in vise and filled it all the way to the top with Bore Tec and left for two days. Washed it and brass brushed the shit out of it.
    Followed by just oil patches. Visually the barrel is now real clean. No improvement though. Cases hanging up exact same spot.

    Plugged it again soaked for 2 days in Bore solvent G96. (This shit nearly knocks you out if you get a wiff of it. Probably similar to @Spook s or @Rushy s crusties)
    Put the brass brush in cordless drill adater and wet brushed the top end. Solvent washed then problem still there. If will not take his two once fired cases.
    I found one of mine out of 10 that fits ejects etc but only one ???? I then polished the case necks on our polisher to the extent I bent one of mine so applied plenty of pressure and polish and they still are tight in the bore.
    The cases show a good firing pin hit, primers look fine no marks on their bottoms at all.

    The rifle has a drop bottom magazine. The mag "box" has been brazed to the action by someone. Could this have damaged the bore?
    Im stuck. After 9 rounds its gone pear shaped for young Josh.. Anyone got any ideas ????? I do not think its still dirty ??
    Next would be to make a mandrel and wrap wet and dry sand paper round it and using a drill hit it again but I reckon that would ruin the rifle ?? (might make the hole too big) Take to gun smith ??

    "This is my Flag... Ill only have the one ..

 

 

Similar Threads

  1. Help needed
    By boomstick in forum Hunting
    Replies: 21
    Last Post: 26-01-2015, 01:50 PM
  2. advise needed
    By rookiesniper in forum Hunting
    Replies: 4
    Last Post: 06-10-2013, 01:16 PM
  3. help needed
    By wile in forum Hunting
    Replies: 1
    Last Post: 30-07-2013, 08:03 AM

Tags for this Thread

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
Welcome to NZ Hunting and Shooting Forums! We see you're new here, or arn't logged in. Create an account, and Login for full access including our FREE BUY and SELL section Register NOW!!