Thread: Another Paulownia CF stock build

@Rich007 @chainsaw an R8 stock would be doable but would need to be a bit inventive. The chassis insert wouldn’t be too much of a problem with a router/mill. It is mainly rectangular. The rear bolt into the chassis comes up through the pistol grip, getting the angle right need need some careful alignment. The slots that the bolt rail slide in can get quite thin walls. You would also need to have a threaded sleeve installed for the front “washer” to be screwed down onto.

Originally Posted by stug

@Rich007 @chainsaw an R8 stock would be doable but would need to be a bit inventive. The chassis insert wouldn’t be too much of a problem with a router/mill. It is mainly rectangular. The rear bolt into the chassis comes up through the pistol grip, getting the angle right need need some careful alignment. The slots that the bolt rail slide in can get quite thin walls. You would also need to have a threaded sleeve installed for the front “washer” to be screwed down onto.

Thanks @stug