If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed.
Did you make a jig for the jeweling Abe or just go for it on the drill press or mill. It looks good.
doe it in the mill mate an the dividing head looks standard to me apart from a little on the bottom where i was a little short on the movment side an was sleepy
then just wanted it over by time i was finished
The old dividing head Your a patient bugger, I thought it looked to symmetrical.
they over lap an intertwine took few times arround to get it done as has the 2 different offsets almost looks standard you see them side by side mine are bigger rounds
Welcome to NZ Hunting and Shooting Forums! We see you're new here, or arn't logged in. Create an account, and Login for full access including our FREE BUY and SELL section Register NOW!!
Bookmarks