Thread: Build yourself a fibreglass stock

Step five
Remove parting board

Once the first side has set (24 hours) gently remove the parting board leaving the stock in place attached to the first mould half. With any luck it will pop off easily.


Step six
Prep second half

Just like on the first half, now fill the inletting with plasticine. Also remove the plasticine out of the alignment pyramids, and clean them out nicely with a cotton bud or something like that. Pay attention to how you fill the bolt handle recess..... that one can be tricky depending on the stock/action design



Then repeat the release wax and hairspray schedule on the second side. Then apply the resin silica mix, then 6 layers of fibreglass as per the first side. Looking good!