If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed.
I use to make the action inlet mold the same way, but after a few uses the silicon ripped apart. I then swapped to useing silicon sealant you get in the tubes. It is a bit of a bugger to work with but is heaps cheaper and a bit more flexible and easier to get out once you have cast the action area.
I did a two part cast like you have, smear the silicon thickly around the edges making sure to push it down into the corners, then leave that to set then fill in the rest. It does take a couple of days for the silicon to set right through.
I put petroleum jelly on the action first to act as a release agent.
Was your release agent for the stock moulding petroleum jelly too?
Welcome to NZ Hunting and Shooting Forums! We see you're new here, or arn't logged in. Create an account, and Login for full access including our FREE BUY and SELL section Register NOW!!
Bookmarks