DIY adjustable gun rest

Made from items at the local Tip Recycled Shop...car scissor jack and broken street works sign

Attachment 148980

Attachment 148981

Good job. Are you going to make it into a 'lead sled' type rest ??

thanks... hmm was planning to just put a sand bag on it as already quite firm ( with only 3 points of contact) lol, i should have grabbed the "caution works ahead" sign that was with it as I could have folded that into a tray...next Tip trip another look in the recycle shop

@muzza2020,

I'm sure that's not what she meant by "Give it a rest, Muzza!"

I'm ashamed to say, I have a similar device, only the jack is a bottle jack and it's an old metal ironing board. Works bloody well,except for when it led to my shooting the bloody chrony.

Looks to me like some sort of marital aid, Muzza....? Mind you, at YOUR age.......

Good old Kiwi ingenuity at its best on display right there Muzza. On ya mate!

@Ranger 888..lol just to confirm its intended purpose.Attachment 148998

Quote:

---

Originally Posted by Rushy

Good old Kiwi ingenuity at its best on display right there Muzza. On ya mate!

---

Cheers mate, nothing like getting out the grinder and welder for a bit of man cave therapy ..most expensive part was the can of spray paint from bunnings

Well done, Muzza, I always said you aren't just a pretty face!

Quote:

---

Originally Posted by muzza

Intrigueing piss-take there Ranger 888 . Only problem is the Muzza with the rifle rest isnt the typing this reply..... hahahaha ;-)

---

lol, no offence taken,,happens with age

I did the same thing. But I used a slide through sleeve and clamp at the Tee where the rear attaches to the scissor so that it separates into two pieces.....

Attachment 149009
Attachment 149010
Attachment 149011

There is a washer fitted as a knob so I can adjust the height from both sides of the jack, and on the bottom leg on one side is another washer as a knob. Turning that tightens the clamp on the centre arm and allows for an adjustable length. (Some of my rifles have sling studs in different places....)

Attachment 149041

Quote:

---

Originally Posted by timattalon

I did the same thing. But I used a slide through sleeve and clamp at the Tee where the rear attaches to the scissor so that it separates into two pieces.....

Attachment 149009
Attachment 149010
Attachment 149011

There is a washer fitted as a knob so I can adjust the height from both sides of the jack, and on the bottom leg on one side is another washer as a knob. Turning that tightens the clamp on the centre arm and allows for an adjustable length. (Some of my rifles have sling studs in different places....)

---

Quote:

---

Originally Posted by muzza2020

Attachment 149041

---

I will say yours is much shinier than my one.......and looks more professional and much less like a sunday knock up in a back yard like mine does......