Thread: Making a Rolling block rifle on my lathe.

Ok, Got the barrel making bit sorted so back to the roller action, it now has two holes drilled for milling clearance and after careful setting up have started milling out the guts where the breach block and hammer goes. I have also rebuild a deck as I could see a bit of rot getting into the old one, so that`s why things are a bit slow, but then what`s the rush . Put in a order for a T/Carbide .450" pull through reamer from the U S, so one run through should see the bore ready for rifling, that`s when I get it, well no rush,
, Two holes.
, Milling started.
, Nice new deck.






,