Thread: Omark improvements

Originally Posted by ebf

Next trip the recoil lug is getting a slight champher on the front edge to make it easier to pull it out of the bedding.

Couple of pillars for the stock to make it metal on metal tightening.

Need to drill holes in the stock for the action bolts. One of the previous trips we drilled and tapped a rear action bolt hole into the action.

Then bedding, keen to learn all about how that is done.

Once I get the completed rifle back I am going to seal, prime and paint the stock.

When I bedded mine I put 3 layers of insulation tape on the fwd edge of the recoil lug and one layer on the sides.