Thread: Reloading Bench

I have been meaning to make a dedicated reloading bench for a while now and finally had some time to do it.
Im certainly no carpenter but I managed to borrow some quality tools from a mate that made things alot easier main one being a drop saw.

I used h1.2 4x2 framing timber and 18mm ply. In hindsight im sure there are cheaper options out there if you shopped around and 12mm ply would probably do the trick.

Had a look at different designs and found this one to be the simplest of the lot. Managed to knock the frame up in a couple of hours, and gave it a quick stain (mainly because it was pink).



Another few hours work the next day to put the top and bottom shelves on fill the holes on the top and give it a stain.



If i did it again i would use hidden brackets to mount the ply, it was a PITA filling all the holes and doesnt look as good as it could.
I ran out of 3" square drive screws as well, using these and an impact driver was really fast so progress slowed a bit while assembling the frame.