Welcome guest, is this your first visit? Create Account now to join.
  • Login:

Welcome to the NZ Hunting and Shooting Forums.

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed.

Ammo Direct Terminator


User Tag List

+ Reply to Thread
Results 1 to 15 of 81
Like Tree154Likes

Thread: Walnut Stock Build

Hybrid View

  1. #1
    Banned
    Join Date
    Mar 2015
    Location
    North Canterbury
    Posts
    5,462
    Quote Originally Posted by PaulNZ View Post
    What would you need to know whether it fits an EM332? I don't have one of those, but I could send you inlet photos and dimensions if you're keen. I expect it'll depend on how much modification you're willing to do...
    The EM is supposed to be a copy of the Match 54 action, so should be close. The EM stock is OK, a bit close or short between the pistol grip and trigger, but is a very soft timber - softer than Radiata even
    Last edited by Moa Hunter; 06-04-2020 at 10:32 AM.

  2. #2
    Member PaulNZ's Avatar
    Join Date
    Sep 2016
    Location
    Waikato
    Posts
    446
    Quote Originally Posted by Moa Hunter View Post
    The EM is supposed to be a copy of the Match 54 action, so should be close. The EM stock is OK, a bit close or short between the pistol grip and trigger, but is a very soft timber - softer than Radiata even
    Pulling up a photo of an EM332 it looks like both action screws might be ahead of the trigger? That could be a problem. I believe that is indeed how the Anschutz Match 54 action is configured, but the sporter 54 action has the rear action screw behind the trigger. You can actually see it in the photo I posted of the tang grinding - the hole right at the back. Here's a few more dimensions from my Anschutz receiver if they're of any use to you anyway:

    • Action Screw Spacing: 176.2mm
    • Rear action screw to rear edge of receiver: 9.8mm
    • Front action screw to rear face of recoil lug: 12.0mm
    • Receiver diameter: 29.8mm

    All dimensions referencing action screws are to the hole centre. I also know where there's a factory classic stock inlet for the same action (but wing safety, not side safety).

 

 

Similar Threads

  1. Walnut stock re-finishing??
    By PerazziSC3 in forum Firearms, Optics and Accessories
    Replies: 3
    Last Post: 25-03-2017, 08:50 AM

Tags for this Thread

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
Welcome to NZ Hunting and Shooting Forums! We see you're new here, or arn't logged in. Create an account, and Login for full access including our FREE BUY and SELL section Register NOW!!