Thread: Modular magnum suppressor

Hi all,

Just finishing off testing on the centerfire modular magnum suppressor, if all goes well it should be ready for sale in two weeks.


Specs
345grams in weight
130mm forward of the muzzle
200mm over the barrel
44.5mm in diameter

Baffle modules are interchangeable with my other modular suppressors.

Suited upto 300win mag
Will sell for about $375 on special.

DPT

Hi darren you got anything for the 90 grains + powder capacity, e.g 338 lapua 338/300RUM etc, in the works?

Hi,

Not at this stage, ill look into it in a few months time.

Darren

Can we see a photo?
thicker walls?

Darren, what would the supression be like with one module/baffle thing less.

A bit louder

Originally Posted by Bill999

A bit louder

I was thinking more in terms of would it have a dramatic effect.

For example, I have a dpt over barell modular on my 243, and I use it with a baffle off because it hardly makes a difference. The advantage is less barrel overhang, and remember the magnum starts off with 1" more overhang.

Originally Posted by Bill999

Can we see a photo?
thicker walls?

It just looks like your over barrel just longer... bigger blast chamber.

Originally Posted by Tahr

I was thinking more in terms of would it have a dramatic effect.

For example, I have a dpt over barell modular on my 243, and I use it with a baffle off because it hardly makes a difference. The advantage is less barrel overhang, and remember the magnum starts off with 1" more overhang.

Sometimes it hard to tell unless you have two exact same rifles setup, shooting one after the other you will notice a difference, the db meter sure notices...

DPT

Sorry mistake, its 150mm over the barrel not 200mm.

So the magnum one has been tested and be ready to go out the door next week.
Will suit upto 300win mag

315grams, 105mm muzzle forward, 150mm over barrel.
$365

DPT

I'll have one please would like it to fit both my .264 mag and .280 rem what size threads do you do ?

Cheers Jeff

Hi Jeff,

Got your PM thanks, can you send the request through to my email please sales@dpt.co.nz
I can do most threads, whats the diameter of both muzzles? I can thread them too if you like, $60 each.

Thanks
Darren

yep will do it tomorrow thanks
Jeff

Hi Darren,

I currently have a very old original Gunworks suppressor (the early one that can be pulled apart, very heavy, without a barrel isolator tube) that i use on my 7mm SAUM. I am interested in one of your new modular overbarrels to replace it.

What is the recoil reduction like with these new modular units, compared with the normal offerings of standard overbarrels? As the recoil reduction is a big buying point for me and this rifle.

Bloody good price too i must say!

Cheers,

GWH