ok I have decided to build a 50,000 ton press. I will need some help with the heavy bits, anyone keen to lend a hand next weekend? Here is a glimpse of what it might look like (will be a different...
Liked On: 27-12-2018, 07:18 PM
I was up at ASC this morning burning up some 9mm, 38 special and 40 S&W. Plenty of room at the inn.
Liked On: 27-12-2018, 06:38 PM
One Andy McNab novel the main character arms himself with a rubber mallet and takes on a group of thugs. He makes a note the mallet is better than a hammer ... does not get stuck in skulls so...
Liked On: 26-12-2018, 11:31 AM
It looks like a very old/early air rifle, like a Diana Gem, but the Gems don't have the piston cylinder going all the way to the toe of the gun. It is actually a bullpup air rifle. Agree don't rush...
Liked On: 24-12-2018, 05:15 PM
get the accuracy sorted, but try to keep them hitting sideways. will probably be quite effective on pestilence....
Liked On: 23-12-2018, 09:32 PM
Although I'm originally English, I lived in France for 14yrs. The gun laws are a lot different there. No firearms safe is required unless you own a handgun. A shooting licence is not a hunting...
Liked On: 23-12-2018, 09:04 PM
Aero Build from NZAR15, DPT Suppressor and Holosun Red Dot, Shoulda got one of these waaaaay sooner !!!! 96182 Big thanks to Ken was awesome to deal with !!!!!
Liked On: 22-12-2018, 07:50 PM
Really? When I used 250ml to try and light a damp woodfire in a hut it only lasted about half a millisecond! By coincidence this was the same amount of time my eyebrows lasted! :o
Liked On: 22-12-2018, 07:46 PM
Another trash article
Liked On: 21-12-2018, 10:50 PM
Very Clever Replayer. I bet that'll take off as an idea.
Liked On: 21-12-2018, 06:41 AM
No Mucko, I've only got three gun drills, they drill holes of , .420", .443", and .500". Its ok drilling holes this size with the setup I have but if you go to smaller holes you need a lot more oil...
Liked On: 20-12-2018, 08:34 PM
Well no, my state of the art cutters are made from T C tipped saw blades and as I`m hand cranking slowly through the barrel with my top of the range C N C set up there`s no wear on the cutter. My...
Liked On: 20-12-2018, 08:31 PM
At the back of the lathe is the setup for rifling register of the six groves, a bracket with a arm is bolted in place and the arm has a pin that locates and locks in a round disc with the evenly...
Liked On: 20-12-2018, 08:29 PM
Aye, too true. We know only too well that the greenies dont want us "cunters" anywhere near their precious view of utopia (which is OUR public land). You might sit on a precious mountain daisy ffs.
Liked On: 20-12-2018, 07:34 PM
Past my bed time. Someone should invent a way to watch shit later.
Liked On: 20-12-2018, 07:29 PM