embrace the skin that forms...it seals in the goodies and helps keep out the badies....simple matter to trim it off before cooking/processing,its going to be mostly silverskin anyway...like the idea...
Liked On: 20-12-2020, 06:02 PM
My only centerfire ,20inch 7saum. Does it all big and small, close and far. 154867
Liked On: 29-11-2020, 09:53 PM
Hodgdon superprofrmance Sent from my CPH1903 using Tapatalk
Liked On: 29-11-2020, 08:24 AM
My barrel copper fouls quiet badly and takes a lot to clean it out. I’m using KG products. 154738
Liked On: 29-11-2020, 08:08 AM
no
Liked On: 26-11-2020, 02:08 PM
Honestly, makes me feel emotional... https://m.facebook.com/watch/?v=429394608453301&_rdr I reckon this ad is the closest thing possible to my gang down on the farm, without it actually being...
Liked On: 24-11-2020, 02:13 PM
Poor Montana has been sitting in the safe patiently waiting for me to stop playing around with cows etc the last few months. Finally got around to loading up some load dev the past few nights. Was...
Liked On: 23-11-2020, 08:17 PM
The 168 NBT is a very good bullet.
Liked On: 21-11-2020, 07:32 AM
42-43grains 2208. 140 bt. Mag length.
Liked On: 17-11-2020, 10:19 PM
Perhaps, I have the 2.5x20 and 4x32 nx8 and the 7x35 atacr and shooting the atacr and the nx8 at over 1300m in fading light they were both pretty similar to my old eyes. They both all were brighter...
Liked On: 15-11-2020, 03:49 PM
Had a fair bit of water in the Ruas the last few days. 153529153530153531153532 So instead of going up the creek I sidled a ridge in the rain. 153533153534153535153536 Plenty of sign,was about...
Liked On: 12-11-2020, 09:20 PM
garyp if the issue is what I think it is. Then it is a simple fix. There is a slot that runs down the side of the bolt, this is what the release sits in....
Liked On: 11-11-2020, 05:55 PM
Plus 1 for the cactus gear. Solid canvas construction can be a bit noisy in the bush but put a fleece top on the outside and you will be good to go for bush hunting. I have the huntaway. Not cheap...
Liked On: 11-11-2020, 07:49 AM
For all the haters of F1, your day has arrived!
Liked On: 10-11-2020, 09:25 PM
A carbide cutting bit is much cheaper to replace than a reamer.
Liked On: 09-11-2020, 09:49 PM