"Eyes wide open " but fell down the same rabbit hole again ( just like me ) I played with sub sonic 44mag 240 XTPs 15 years ago and gave up Ran the 90 grain XTPs in my 308 to shoot hares to...
Liked On: 10-11-2023, 03:15 AM
It's pretty easy to straighten a bent barrel. I did a mates 308 barrel massively bent on a quad bike roll over. Honestly I thought even if I got it straight there would have been out of round. ...
Liked On: 10-11-2023, 12:37 AM
This will be good ! I will watch and listen before I comment on Really Old vs New
Liked On: 09-11-2023, 09:20 PM
This will be good ! I will watch and listen before I comment on Really Old vs New
Liked On: 09-11-2023, 09:16 PM
I finally got around to doing some loads for the 222R Hornady 55 SP BM2 22.0 grains Bertram 222R brass I just picked a mid range load because I don't want to squander components And it's a...
Liked On: 09-11-2023, 09:12 PM
This will be good ! I will watch and listen before I comment on Really Old vs New
Liked On: 09-11-2023, 09:06 PM
This will be good ! I will watch and listen before I comment on Really Old vs New
Liked On: 09-11-2023, 08:41 PM
Plumbing tape and O ring on muzzle thread hints at another major fault
Liked On: 09-11-2023, 07:19 PM
It's pretty easy to straighten a bent barrel. I did a mates 308 barrel massively bent on a quad bike roll over. Honestly I thought even if I got it straight there would have been out of round. ...
Liked On: 09-11-2023, 07:05 PM
It's pretty easy to straighten a bent barrel. I did a mates 308 barrel massively bent on a quad bike roll over. Honestly I thought even if I got it straight there would have been out of round. ...
Liked On: 09-11-2023, 01:59 PM
I finally got around to doing some loads for the 222R Hornady 55 SP BM2 22.0 grains Bertram 222R brass I just picked a mid range load because I don't want to squander components And it's a...
Liked On: 09-11-2023, 01:33 PM
I finally got around to doing some loads for the 222R Hornady 55 SP BM2 22.0 grains Bertram 222R brass I just picked a mid range load because I don't want to squander components And it's a...
Liked On: 09-11-2023, 10:51 AM
I went with a big free standing Ironside 220 litre cabinet sand blaster Just running some glass at the moment that came with it But will switch to garnet when I get to town and pick some up ...
Liked On: 08-11-2023, 09:03 PM
My workshop is in my largely unused ( semi retired ) joinery workshop and i have plenty of extraction. I just need to find a semi permanent location for it and hook it up to the nearest inlet
Liked On: 08-11-2023, 07:43 PM
I went with a big free standing Ironside 220 litre cabinet sand blaster Just running some glass at the moment that came with it But will switch to garnet when I get to town and pick some up ...
Liked On: 08-11-2023, 07:42 PM