Bill999
Member

2149 Likes

Page 49 of 144 First ... 353637383940414243444546474849505152535455565758596061626399 ... Last

• Jump to page:

1. 
   Bill999 liked post by shooternz On thread : 400gr 44magnum loads

   MD pity you live so far away I have just set up my Dillon 550 to load .44 mags, If you don't want pass throughs use the 270 HP's, A customer in Nelson is a Pest control contractor he uses the 280...

   Liked On: 08-07-2022, 04:29 PM

2. 
   Bill999 liked post by The bomb On thread : 400gr 44magnum loads

   Yep that’s my old 77/44..have pmed you my old data.

   Liked On: 08-07-2022, 04:29 PM

3. 
   Bill999 liked post by Moa Hunter On thread : 400gr 44magnum loads

   I have not tried Roberts cast bullets, but I am sure that they are good. What I have found very good are the Nosler 300 gr HP. Very soft lead. Regarding the 400's, I would re-calculate the twist...

   Liked On: 07-07-2022, 11:55 PM

4. 
   Bill999 liked post by The bomb On thread : 400gr 44magnum loads

   Yea bud,pm me your address and I will send you some to try.

   Liked On: 07-07-2022, 11:11 PM

5. 
   Bill999 liked post by The bomb On thread : 400gr 44magnum loads

   Second thoughts you should just sell me the 77/44 back!!always regret selling the hammer..

   Liked On: 07-07-2022, 11:11 PM

6. 
   Bill999 liked post by shooternz On thread : 400gr 44magnum loads

   I make a .44 cal 270 grain HP and a 280 grain FP, Not hard cast The mix I use is about 30:1 Lead to Tin, With sub loads the 270 HP stays in and the 280 FP trucks on out the other side I don't...

   Liked On: 07-07-2022, 11:08 PM

7. 
   Bill999 liked post by Makros On thread : Trusted 18650 suppliers?

   Jacob at https://www.piercingthedarkness.co.nz/ one of the forum sponsors. Good guy and good gear.

   Liked On: 07-07-2022, 11:28 AM

8. 
   Bill999 liked post by LJP On thread : 400gr 44magnum loads

   I have special order 15" Shilen select match stainless barrel in 44 with 1-16" twist that I ordered for a project gathering dust. Would need fitting & chambering but would be perfect for what your...

   Liked On: 07-07-2022, 09:21 AM

9. 
   Bill999 liked post by Philipo On thread : Lever Actions choices

   Just my 2cents worth, If you've never used a "Marlin - Winny" type lever than you better practice ya "cowboy" finger flick, I had never really been into levers & even stupidly brought a Marlin, that...

   Liked On: 06-07-2022, 08:03 PM

10. 
    Bill999 liked post by Moa Hunter On thread : Suppressors

    Weighed just now 498 grams. It is muz forward and 290mm long.

    Liked On: 05-07-2022, 07:27 PM

11. 
    Bill999 liked post by Van On thread : Gun Porn, show off your new toys

    A few new, a few of my older builds... enjoy. Christensen arms MPR in 6.5PRC 199472 Tikka CTR in ESS chassis in 260AI 199473 Howa 1500 in LSS chassis 13 inches, 308 199474

    Liked On: 05-07-2022, 11:04 AM

12. 
    Bill999 liked post by tikka On thread : 7mm08 or .243 Subsonic round

    It all depends on what you want to accomplish? plinking, 100% of the day ninja quiet pest control, supersonic in the morning and evenings for longer range deer then subs putting a wounded animal down...

    Liked On: 05-07-2022, 10:01 AM

13. 
    Bill999 liked post by Carbine On thread : 7mm08 or .243 Subsonic round

    even the Winchester stuff have some 185gr subsonic Winchester, they also have i think 168gr stuff, always have in my pocket incase i have the time to load one and target oblivious close animals or...

    Liked On: 05-07-2022, 09:34 AM

14. 
    Bill999 liked post by winaa On thread : 7mm08 or .243 Subsonic round

    Hunting with dogs, looking after your own hearing, not disturbing deer in the next valley if you want to carry on hunting, and for smaller calibers point blank dispatching shots. There's lots of...

    Liked On: 05-07-2022, 09:04 AM

15. 
    Bill999 liked post by shooternz On thread : 7mm08 or .243 Subsonic round

    You wil probably have stability problems with 150 gr bullets in the 7mmo8 the standard 1:9.5" and 1:9" twists mat not stabilise them the 120 grain is the best option, Same with the .243 use the...

    Liked On: 05-07-2022, 08:43 AM

Page 49 of 144 First ... 353637383940414243444546474849505152535455565758596061626399 ... Last

• Jump to page: