Ken (who owns 55SIX) is a good bastard. Highly recommend, prices are probably the best too
Liked On: 05-10-2021, 10:30 AM
+1 for Ken.
Liked On: 05-10-2021, 10:30 AM
Greetings again kayneb, I saved the image and zoomed in to get a better look. There are no scrape marks on the forward side of the gouge. This and the fact you had other rounds with this mark leads...
Liked On: 20-09-2021, 11:02 PM
Correct, this is what you should do to set the fls die for your individual rifle.
Liked On: 20-09-2021, 11:02 PM
Hi Bhess. Keep an eye out for some of the vhitavouri powders as there maybe something that's similar burn rate to 2206h or cfe223. The other powder I'd look at which I've just used to work up a...
Liked On: 20-09-2021, 10:37 PM
Haha I hear its been replaced with the 6.5 Creed tho ....
Liked On: 19-09-2021, 09:08 AM
charliehorse Thank you for pointing out something I should have spotted much sooner.... All the years I have been on here and I never noticed. Problem solved. I figured there had to be a way t do...
Liked On: 13-09-2021, 10:04 PM
WTB, FS, Swap, Free These are the prefixes at the start of all posts in the Buy, Sell or Swap section. As long as person posting does their part, it seems to make sense to me. It just means a...
Liked On: 13-09-2021, 10:03 PM
Does Alan Newnham still do it. Philipo He reloaded for me before I got my a into g. Few years back now though.
Liked On: 12-09-2021, 03:52 PM
Some, perhaps many, of us reload for friends, family, neighbours. I recently developed loads for an older club member. He supplied me with brass, I supplied projectiles, powder and primers. I loaded...
Liked On: 12-09-2021, 03:52 PM
ok exactly what I needed thank gentlemen. I'll go with the 10s and adjust the fit with socks one way or the other. And putting some cushion insoles in is definitely desirable for me. cheers everyone
Liked On: 08-09-2021, 10:18 PM
Maybe post this in the buy, sell, swap section (https://www.nzhuntingandshooting.co.nz/f13/)?
Liked On: 07-09-2021, 11:54 PM
Greetings, 176338 Found my old .303 FL die. Made by Lyman and cost $4.95, probably in the late 1970's. Sized in a bench vice and then the case knocked out with the rod. Probably needed a socket as...
Liked On: 28-08-2021, 02:42 PM
This is a no-brainer. $NZ 450 landed including GST collected by Amazon vs $650 local (and nobody has any stock so that's that) I've always found Amazon very reliable and this is the official RCBS...
Liked On: 28-08-2021, 10:20 AM
Greetings Countryside, The thread I mentioned was called "Keeping it Simple for New Handloaders" and the last post was on 13/01/21. I suggest you have a look at it and (I can't stress this too much)...
Liked On: 24-08-2021, 07:09 PM