there seems to be a general state of hysteria & over-reaction to a one-off tragic terrorist event. Police still toting guns is one example - especially in rural & small town NZ. Perhaps still in...
Liked On: 09-04-2019, 05:38 PM
I wounder if they will try and make pistol grips et al illegal as well, my poor little 410 Enfield looks like it wont be legal anymore either
Liked On: 09-04-2019, 02:04 PM
funnily enough they are going to increase fines for firearms offences now to ensure our compliance but didn't do it before when we wanted it to stop civil gun crime
Liked On: 08-04-2019, 06:10 PM
Cordite I do understand that. They just better pay up or as I have suggested there will be some that wont. Some will for sure because we are generally honest but it will be like OZ. They did get paid...
Liked On: 08-04-2019, 11:35 AM
If shooting a common caliber just get a lee loader kit.i started with one years ago and still load with it sometimes even tho I have a press set up.
Liked On: 08-04-2019, 10:51 AM
Hear hear https://youtu.be/TK0AIjRzIM4
Liked On: 07-04-2019, 09:56 PM
I remember when I started out reloading it was from helpful people showing me how & shearing there gear , iv got the most basic setup I think it cost $230 delivered , lee kit from reloaders but it...
Liked On: 07-04-2019, 07:57 PM
Hey. I might have sorted it! The tops were a little crushed and I think they weren’t making good contact with the charger posts. Fingers crossed but they’re charging now.
Liked On: 07-04-2019, 06:43 PM
Protected cells will often fail when the circuit board dies or the battery voltage gets too low and the protection circuit will not allow them to recharge. The unprotected cell itself has a 'one...
Liked On: 07-04-2019, 05:53 PM
you can use mine. you break it you bought it
Liked On: 07-04-2019, 04:55 PM
Make sure you can still open the safe door!!!
Liked On: 05-04-2019, 09:08 PM
I don't hate ya mate, welcome aboard
Liked On: 05-04-2019, 01:25 PM
I did buy my own copy of QL hence why I only need the newest values. I add my own bullets by measuring etc but I cant do this with powders. It is an absolute pain the get updates from Quickload...
Liked On: 04-04-2019, 07:31 PM
Not sure how - remove the hinged floor plate maybe and adapt (or maybe you can buy) an external mag in Does this look like something "anyone" would consider modifying Can you imagine watching this...
Liked On: 02-04-2019, 06:48 PM
And in the daytime can get R93 to do the symbol 108253
Liked On: 02-04-2019, 12:48 PM