dannyb
Unapologetic gun slut

13282 Likes

Page 372 of 886 First ... 272322358359360361362363364365366367368369370371372373374375376377378379380381382383384385386422472872 ... Last

• Jump to page:

1. 
   dannyb liked post by Tikka7mm08 On thread : CDS turret help

   A plug for Ben at NZ Asia the agent. Reply email to dial request under an hour.

   Liked On: 12-10-2021, 08:29 PM

2. 
   dannyb liked post by zimmer On thread : Losing my mind...

   Yeah the Supercheap Auto Fish Oil Spray does leave a bit of a dead shark odour for a while but it's pretty well deoderised, not like the old fisholene of years ago which did hum for ages. I think...

   Liked On: 12-10-2021, 07:19 PM

3. 
   dannyb liked post by dogmatix On thread : Wtb 308

   Welcome to the forum. You might get a better response posting an introduction first (https://www.nzhuntingandshooting.co.nz/f34/) and posting your wanted ad in the Buy, sell and swap section...

   Liked On: 12-10-2021, 07:16 PM

4. 
   dannyb liked post by 257weatherby On thread : Recipe for Howa 1500 .308

   Currently at 45.5 2206h pushing a 165 Targex and 47gn 2206h pushing a 150 Speer Hotcor. I don't reckon you can get enough stick powder in the case to get into trouble. Ball powder and mag primers...

   Liked On: 12-10-2021, 02:04 PM

5. 
   dannyb liked post by On thread : Losing my mind...

   Just dry it out and spray fish oil into it is the old school way

   Liked On: 12-10-2021, 02:03 PM

6. 
   dannyb liked post by ebf On thread : Losing my mind...

   Thanks for all the suggestions boys... Problem solved :thumbsup: And the smartie prize goes too....... gun guy and berg243 Sill drain hole on the driver side plugged with some central plateau...

   Liked On: 12-10-2021, 12:55 PM

7. 
   dannyb liked post by ebf On thread : Ultralight Hunting Gear List

   Whoohoo, tx to the Exped Lightning pack I got of gimp a couple of weeks ago, and the tip from joelhenton about the discount on quilts at Hammock Gear (fits nicely into my tiny Macpac drybag as well...

   Liked On: 12-10-2021, 12:32 PM

8. 
   dannyb liked post by Tikka7mm08 On thread : Sticky bolt after second shot

   Yes I trim my front scope screws...a bit of the wife's or MSL's lipstick on the bottom of the front mount screw will let you see if there is contact. I think if was carbon it would do it every shot....

   Liked On: 12-10-2021, 12:31 PM

9. 
   dannyb liked post by Von Gruff Knives On thread : Various Knives

   A few ready for epoxy and pins https://i.imgur.com/RMzjP55l.jpg

   Liked On: 12-10-2021, 08:26 AM

10. 
    dannyb liked post by BRADS On thread : Losing my mind...

    Exactly what he said Sent from my SM-G986B using Tapatalk

    Liked On: 11-10-2021, 09:28 PM

11. 
    dannyb liked post by 7mmsaum On thread : Losing my mind...

    Water in the bottom of either your drivers door or passengers door, normally the passengers door Poke a knitting needle or wire up into the drainage hole as they will be blocked sometimes...

    Liked On: 11-10-2021, 09:28 PM

12. 
    dannyb liked post by Russian 22. On thread : goat stew differing results, any ideas ?

    honestly the best way to cook goat is to give it to your indian friend, that's what I ended up doing. his middy cooked it up mint and they'd give me an ice cream container full of the stuff in...

    Liked On: 11-10-2021, 09:27 PM

13. 
    dannyb liked post by deer243 On thread : goat stew differing results, any ideas ?

    Have you guys not heard of slow cookers??? I do a few stews, beef, goat, venison etc and just chuck it all in the slow cooker and leave it on low for 8 to 12 hours(8 normally fine) Always comes...

    Liked On: 11-10-2021, 08:39 PM

14. 
    dannyb liked post by NZShoota On thread : Howa 1500 10 round mag conversion ? School me up

    Its the website for the detachable mags kits produced by MDT.

    Liked On: 11-10-2021, 08:27 PM

15. 
    dannyb liked post by 7mmsaum On thread : 270win and AR2217 powder info

    58 or 59g of ADI 2217 for 140 grainers in long COL ammo in long throated tikkas and Sakos Work up to this load 2217 is probably the most temp stable powder on this planet

    Liked On: 11-10-2021, 02:26 PM

Page 372 of 886 First ... 272322358359360361362363364365366367368369370371372373374375376377378379380381382383384385386422472872 ... Last

• Jump to page: