Hahn
Member

74 Likes

Page 3 of 5 First 12345 Last

• Jump to page:

1. 
   Hahn liked post by dannyb On thread : 30-06ai 60 series custom landcruiser build

   Spent another 3 hours on the cruiser today, most of the loom is back in, the heater and aircon fans, ducting and blower motor and such is now in situ back under the dash where it belongs. Hopefully...

   Liked On: 05-05-2023, 07:51 PM

2. 
   Hahn liked post by Tahr On thread : Calibre, Rifle & Scope Sugestions For Longer Range Hunting

   If you say 500yds once you have done that you will want to extend further. So a bit of grunt will be required. The 08 based cases might not hack it. I actually think that one of the best cases for...

   Liked On: 12-04-2023, 07:59 PM

3. 
   Hahn liked post by Ryan_Songhurst On thread : Interesting Swarovski PDF

   Found on Rokslide. Might be of interest to some. Good little summary of the company history, models and identification and light transmission comparisons etc. Don't look at comparisons if you're a...

   Liked On: 21-11-2022, 05:30 PM

4. 
   Hahn liked post by Micky Duck On thread : 6.5 v 7mm

   piss off Noddykins...take a .270w projectile and your micrometer/fancypants measuring stick....and then tell me its not 7mm.... the projectiles fired from a .270 winchester are closer to 7mm than any...

   Liked On: 23-10-2022, 10:20 AM

5. 
   Hahn liked post by RUMPY On thread : 6.5 v 7mm

   Curiosity got the better of me and I had to know. https://en.m.wikipedia.org/wiki/Caliber

   Liked On: 22-10-2022, 09:52 PM

6. 
   Hahn liked post by RUMPY On thread : 6.5 v 7mm

   I'm not sure but could be to do with barrel diameters, either inner or outer rifling measurement.

   Liked On: 22-10-2022, 09:52 PM

7. 
   Hahn liked post by gundoc On thread : Torqueing screws for cheapskates

   Complete waste of time! Just nip them up firmly with a drop of LocTite on the threads (bases only). After fitting literally thousands of scopes over the past 60 years I believe torquing scope screws...

   Liked On: 10-10-2022, 09:05 PM

8. 
   Hahn liked post by Hunteast On thread : Anybody used fly on lure fishing rod trout?

   When trout fishing high country lakes in Canterbury that allow spin rods, i often tie a Hamills Killer half a metre off the single hook on a tassie lure. At times the trout smash the Hamills Killer...

   Liked On: 21-09-2022, 08:27 PM

9. 
   Hahn liked post by Forestry On thread : Branch/Leatham 4WD and Hunting

   Was about 12m3 before going in and I got the Hilux up to Bottom Gordons. A few tricky crossings with the boulders but not too bad. A great place for an explore. Went for a big walk and fly...

   Liked On: 06-03-2022, 08:32 PM

10. 
    Hahn liked post by JohnDuxbury On thread : Barrel break-in

    Just shoot it normally and clean it afterwards. Amounts to the same thing. "Barrel break in" is a voodoo that is a waste of perfectly good ammo. If a soft copper bullet could smooth imperfections in...

    Liked On: 24-02-2022, 08:58 AM

11. 
    Hahn liked post by 40mm On thread : Emptying an underfloor tank

    put an airline into the fill hole, with a rag tightly bunged in (and around the airline) to seal it off. Turn the air on and it will blow it all through. If you want to syphon it out through the...

    Liked On: 20-02-2022, 10:39 AM

12. 
    Hahn liked post by Tahr On thread : What will the hunting rifles of the future look like ?

    I would like to hear what ebf has too say about this :) :thumbsup:

    Liked On: 04-02-2022, 12:53 PM

13. 
    Hahn liked post by Moa Hunter On thread : monster stag in taihape - www.mytaihape.com

    Not even a photo from this year the wanker. Look at the grass and the animal - photo is March at earliest

    Liked On: 19-01-2022, 07:47 AM

14. 
    Hahn liked post by tetawa On thread : Night vision vs hunting torch update.

    Not the only one who misses Phil H input on night vision.

    Liked On: 17-01-2022, 06:31 PM

15. 
    Hahn liked post by Dundee On thread : Catch Any Trout Today?

    Any word on your prize yet? Just seen this post come up below. Nearly half of the tags have been handed in from the Lake Argyle tag comp, and the first of the $500 Henderson's vouchers has...

    Liked On: 17-01-2022, 05:37 PM

Page 3 of 5 First 12345 Last

• Jump to page: