Kiwi Greg
Terminator Products

6313 Likes

Page 364 of 421 First ... 264314350351352353354355356357358359360361362363364365366367368369370371372373374375376377378414 ... Last

• Jump to page:

1. 
   Spanners liked post by Kiwi Greg On thread : T1 Terminator Muzzle Brake

   I have had a few requests for a muzzle brake smaller than the T2 Terminator for light weight, skinny barrelled rifles. I designed it with the .223 up to 7mm Rem Mag calibres in mind. It is...

   Liked On: 22-12-2014, 08:58 PM

2. 
   Spanners liked post by Kiwi Greg On thread : New Generation T5

   I have redesigned the T5 Terminator muzzle brake to bring it into line with the rest of my range of brakes. It’s primarily aimed at Cheytac type capacity cases. Here is next to a 350 SMK in the...

   Liked On: 22-12-2014, 08:57 PM

3. 
   veitnamcam liked post by Kiwi Greg On thread : T1 Terminator Muzzle Brake

   I have had a few requests for a muzzle brake smaller than the T2 Terminator for light weight, skinny barrelled rifles. I designed it with the .223 up to 7mm Rem Mag calibres in mind. It is...

   Liked On: 22-12-2014, 08:56 PM

4. 
   kokako liked post by Kiwi Greg On thread : T1 Terminator Muzzle Brake

   I have had a few requests for a muzzle brake smaller than the T2 Terminator for light weight, skinny barrelled rifles. I designed it with the .223 up to 7mm Rem Mag calibres in mind. It is...

   Liked On: 22-12-2014, 08:36 PM

5. 
   Ranal liked post by Kiwi Greg On thread : .284

   As I'm sure has been pointed out before, the problem with modular suppressors is you can take them apart. All suppressors with alloy internals suffer from erosion. The shorter the barrel (bush...

   Liked On: 19-12-2014, 06:06 AM

6. 
   Yukon liked post by Kiwi Greg On thread : Hutt etiquette

   We have a contract to make some lockable storage units for rifles in DOC huts around the top of the south. These with have a SS wire restraint & all the hunter needs to do is bring a small padlock...

   Liked On: 17-12-2014, 04:08 PM

7. 
   Pengy liked post by Kiwi Greg On thread : Hutt etiquette

   We have a contract to make some lockable storage units for rifles in DOC huts around the top of the south. These with have a SS wire restraint & all the hunter needs to do is bring a small padlock...

   Liked On: 16-12-2014, 11:06 AM

8. 
   Dawg liked post by Kiwi Greg On thread : Hutt etiquette

   We have a contract to make some lockable storage units for rifles in DOC huts around the top of the south. These with have a SS wire restraint & all the hunter needs to do is bring a small padlock...

   Liked On: 15-12-2014, 09:19 PM

9. 
   Toby liked post by Kiwi Greg On thread : Hutt etiquette

   We have a contract to make some lockable storage units for rifles in DOC huts around the top of the south. These with have a SS wire restraint & all the hunter needs to do is bring a small padlock...

   Liked On: 15-12-2014, 09:05 PM

10. 
    Yukon liked post by Kiwi Greg On thread : Testimonials

    I thought I would start a thread to put some unsolicited testimonials in :)

    Liked On: 12-12-2014, 05:03 PM

11. 
    Lorne liked post by Kiwi Greg On thread : Twist rate vs velocity vs bc

    They were early Lehigh .416, 435 grain brass projectiles, the lack of diameter & engraving most likely caused this coupled with the 1-12 twist & 3200 fps. They would slide in the bore getting the...

    Liked On: 09-12-2014, 09:17 PM

12. 
    Lorne liked post by Kiwi Greg On thread : Twist rate vs velocity vs bc

    My Ex Cryzman 26", 1-7, 22-243 shooting the 90 Bergers at 3100-3300fps is extremely accurate. The trouble starts when the barrel gets warm, the warmer it gets the lower the velocity threshold is...

    Liked On: 09-12-2014, 12:13 AM

13. 
    Lorne liked post by Kiwi Greg On thread : Twist rate vs velocity vs bc

    I haven't seen the targets but apparently there is a nice round hole with a wee bit out of the top made by the tip. These bullets are extreme, they are 2.312", 58.72mm long with a BC of 1.03

    Liked On: 09-12-2014, 12:08 AM

14. 
    Lorne liked post by Kiwi Greg On thread : Twist rate vs velocity vs bc

    In Bryan Litzs latest book he says the difference in velocity from slow to fast twist is typically less than the usual ES so basically no difference. Also a faster twist on a bullet gives it a...

    Liked On: 09-12-2014, 12:07 AM

15. 
    199p liked post by Kiwi Greg On thread : Twist rate vs velocity vs bc

    My Ex Cryzman 26", 1-7, 22-243 shooting the 90 Bergers at 3100-3300fps is extremely accurate. The trouble starts when the barrel gets warm, the warmer it gets the lower the velocity threshold is...

    Liked On: 08-12-2014, 09:15 PM

Page 364 of 421 First ... 264314350351352353354355356357358359360361362363364365366367368369370371372373374375376377378414 ... Last

• Jump to page: