kristopher
Member

426 Likes

Page 7 of 29 First 123456789101112131415161718192021 ... Last

• Jump to page:

1. 
   kristopher liked post by Lambie On thread : Food Dehydrator

   We brought a Sunbeam "Food Lab" dehydrator about 4 years ago, it has slide out trays in a cabernet style dehydrator. It's easier to use than the old round ones. I've been dehydrating my meals for a...

   Liked On: 23-12-2024, 04:27 PM

2. 
   kristopher liked post by Fssprecision On thread : The 300 Blackout lives :-)

   I got round to making the 300 Blackout (thanks for those who commented to the earlier post), based on a Howa 1500, I cut the barrel down and reduced the profile. I then tried a couple of baffle...

   Liked On: 23-12-2024, 04:22 PM

3. 
   kristopher liked post by Billbob On thread : Knife sharpeners you’d recommend

   Shouted myself this. Got it from Sydney tools in chch link below. Got my favourite pocket knife razor sharp in a couple of minutes at a 20° angle. Next knife was a cheap kitchen knife blunt as a...

   Liked On: 20-12-2024, 05:47 AM

4. 
   kristopher liked post by Moutere On thread : Knife sharpeners you’d recommend

   My suggestion is to decide on your budget first.

   Liked On: 20-12-2024, 05:24 AM

5. 
   kristopher liked post by TeRei On thread : Best knife sharpeners

   https://www.nzhuntingandshooting.co.nz/f22/knife-sharpeners-you%92d-recommend-97158/ Lend me your ear while I tell you a tale about a sharp knife that I learnt on the Forum, it is about a blunt...

   Liked On: 20-12-2024, 05:19 AM

6. 
   kristopher liked post by gonetropo On thread : Rip off of the week

   regarding x-trails, they come with a tyre profile 65. if you keep the same width and go 70 profile the speedo will be correct. also if they over rev on idle the on board diagnostics will tell you...

   Liked On: 19-12-2024, 01:23 AM

7. 
   kristopher liked post by Micky Duck On thread : Huntech butchers coat

   Awesome bit of kit for carting out animals of just pottering around in damp and/or cold conditions...however it was almost too much of a good thing and I found myself too warm if wearing it for any...

   Liked On: 18-12-2024, 05:08 PM

8. 
   kristopher liked post by gonetropo On thread : Rip off of the week

   i have to love the home handyman who works on modern car electrics. had a young fella turn up with the engine management unit he had tried to re-chip himself. circuit print torn off the pcb etc....

   Liked On: 16-12-2024, 08:21 AM

9. 
   kristopher liked post by Grey Kiwi On thread : Rip off of the week

   I'm from the days of twin carb Mini Coopers, MG's (the real ones...not the Chinese ones), big old Wolseley 6/99 and 6/110, etc. No sweat to clean and tune twin carbs. But try and find some one...

   Liked On: 16-12-2024, 08:13 AM

10. 
    kristopher liked post by Finnwolf On thread : Rip off of the week

    I feel for you on this l! When a lot younger and dumber I had a Mk2 Zody over a pit that had 2” of water in the bottom of it, thought the rear of the gearbox was just a cover of some sort so undid...

    Liked On: 16-12-2024, 07:17 AM

11. 
    kristopher liked post by blip On thread : Rip off of the week

    We get that a lot. Thought id just get a cof before we head off. But but i need it fixed now. Some times I need to check our name of our shop as sometimes I think we must be called piece of shit...

    Liked On: 16-12-2024, 06:43 AM

12. 
    kristopher liked post by scotty On thread : Rip off of the week

    yea we usually get the campervan and bus owners rolling in 2 weeks befor xmas "my camper has failed its warrant heres a list 5 times longer than the ten commandments i need it fixed before the 20th"...

    Liked On: 16-12-2024, 06:11 AM

13. 
    kristopher liked post by 19Badger On thread : Rip off of the week

    Those old gearboxes were so easy to do, the problem as you say is the damage the person that stripped it caused and the damaged and missing parts. Recently had two tubs of parts dropped off and...

    Liked On: 16-12-2024, 06:10 AM

14. 
    kristopher liked post by Grey Kiwi On thread : Rip off of the week

    Years ago a young guy came into the garage with a sugar bag full of gears, shafts, bearings, loose needle rollers, and the (now empty) gearbox casing from a Mk2 Zephyr. Could I please check it over,...

    Liked On: 14-12-2024, 05:53 PM

15. 
    kristopher liked post by jusepy81 On thread : Rip off of the week

    Yep , Not all mechanics are rip off. There is a reason it is a trade.

    Liked On: 14-12-2024, 06:35 AM

Page 7 of 29 First 123456789101112131415161718192021 ... Last

• Jump to page: