I’ve tried boiling and burying and found it just makes a huge mess or more work for me. I head skin, pop the eyes, and remove the jaw. Leave it exposed for a day for the flies, then wrap it in a...
Liked On: 21-09-2020, 09:38 AM
I think just leave it & use as is, yes rear sight but not base is easy to remove, no pin does NOT drive out, you push whole sight down & back, the spring holds it up into a recess, put them together...
Liked On: 03-09-2020, 10:09 PM
Oh god will it never end
Liked On: 01-07-2020, 03:18 PM
Here's one of Kudu pups. Not to ready to hunt yet but showing good potential. 143156
Liked On: 22-06-2020, 06:06 PM
Tried AR2209 and Re16 with 120 ballistic tips and 120 ttsx's recently. 20" barrel. 120nbt/ar2209/winchester brass/cci250/2.975" (brass simply sized, chamfered, deburred, and loaded) 54.3 2918...
Liked On: 09-06-2020, 09:18 AM
The 'Deer & Mountains' packet came out in the late 60's and are quite collectable in good condition. The FN box is part of a large batch that the NZFS imported from Belgium for culler use. It was...
Liked On: 07-05-2020, 07:40 AM
It is Fabrique Nationale Belgium AKA FN. I was given a pile of once fired brass many years ago. The lot I had was all boxer primed.
Liked On: 06-05-2020, 06:52 PM
Greetings, I bought some of the CAC stuff in boxes like that in the late sixties, cost thirty bob ($3.00) a packet. Likely to be Berdan primed. There may be collector interest in it, perhaps a lot....
Liked On: 06-05-2020, 06:27 PM
Just for interestes sake: Had Dad's .222 vixen out yesterday to shoot a fallow spiker and also tested some of my 6.5 loads (CM and PRC). Put the magnetospeed on the vixen and fired 2 shots...
Liked On: 03-05-2020, 12:37 PM
Hi Kudu How are you? I use 2207 in 222 Sako with 50 Bal tips, very accurate load and hits hard. I think all 222's are inherently accurate due to the longish neck, and I have used the Hornady SX 50...
Liked On: 01-05-2020, 07:27 PM
I think the .222 tends to be one of those cartridges that is very easy to load for. Many different powders seem to work well in them, but its projectile range is narrowish.......... given that many...
Liked On: 30-04-2020, 08:38 PM
IMR3031 worked for me. 138181 And AR2207 138182 Sako L461 and AII.
Liked On: 30-04-2020, 08:38 PM
Greetings Kudu, The go to load for the .222 R seems to have been 20.5 grains of IMR or H 4198 (AR 2207) behind a flat base 50 grain projectile just about forever. Well since 1950 anyway. The 14 inch...
Liked On: 30-04-2020, 06:48 PM
Iv got 2206h and 2208 on hand locally if you dont have any and just want to trial some loads
Liked On: 24-04-2020, 01:10 PM
52grn speer HP and the 50 grn hp will do the job nicely in your fox......if its anything like the one I used years back...that popped up on here forsale...it wont be fussy.
Liked On: 24-04-2020, 07:15 AM