m101a1
Member

376 Likes

Page 13 of 26 First 1234567891011121314151617181920212223242526 Last

• Jump to page:

1. 
   tetawa liked post by m101a1 On thread : Call that a dog? Are there any...?

   223544 corgi pretty loyal solid and a big bark , also you cant run without ankles . Also I think with the smaller breeds you can pick them up as you get older and weaker

   Liked On: 10-05-2023, 06:16 PM

2. 
   Andygr liked post by m101a1 On thread : Call that a dog? Are there any...?

   223544 corgi pretty loyal solid and a big bark , also you cant run without ankles . Also I think with the smaller breeds you can pick them up as you get older and weaker

   Liked On: 10-05-2023, 11:26 AM

3. 
   Moa Hunter liked post by m101a1 On thread : Call that a dog? Are there any...?

   223544 corgi pretty loyal solid and a big bark , also you cant run without ankles . Also I think with the smaller breeds you can pick them up as you get older and weaker

   Liked On: 10-05-2023, 11:11 AM

4. 
   Snap 4T liked post by m101a1 On thread : Call that a dog? Are there any...?

   223544 corgi pretty loyal solid and a big bark , also you cant run without ankles . Also I think with the smaller breeds you can pick them up as you get older and weaker

   Liked On: 10-05-2023, 11:01 AM

5. 
   rugerman liked post by m101a1 On thread : Call that a dog? Are there any...?

   223544 corgi pretty loyal solid and a big bark , also you cant run without ankles . Also I think with the smaller breeds you can pick them up as you get older and weaker

   Liked On: 10-05-2023, 10:59 AM

6. 
   XR500 liked post by m101a1 On thread : Call that a dog? Are there any...?

   223544 corgi pretty loyal solid and a big bark , also you cant run without ankles . Also I think with the smaller breeds you can pick them up as you get older and weaker

   Liked On: 10-05-2023, 10:50 AM

7. 
   7mmwsm liked post by m101a1 On thread : Gun cabinet - questions

   stepped plates on inside so even if hinges cut off you cant pull door out and shields over padlocks so cant get to shackles bit like forestry gates .

   Liked On: 01-05-2023, 11:49 AM

8. 
   XR500 liked post by m101a1 On thread : Legal length.

   So its the fault of that greek barstard Pythagoras again fuck he caused some grief as an apprentice builder .

   Liked On: 29-04-2023, 08:58 AM

9. 
   XR500 liked post by m101a1 On thread : Getting a Farm bike road registered ???

   Go the A rego / atv way first dun it a few times with quads not continuous either so cheaper then get a wof and just change to a g rego but then its cont rego and a wof before each renewal Dont go to...

   Liked On: 19-04-2023, 08:33 AM

10. 
    Pete_D liked post by m101a1 On thread : Getting a Farm bike road registered ???

    Go the A rego / atv way first dun it a few times with quads not continuous either so cheaper then get a wof and just change to a g rego but then its cont rego and a wof before each renewal Dont go to...

    Liked On: 18-04-2023, 10:39 PM

11. 
    Tertle liked post by m101a1 On thread : 4x4 Paint job options

    Easier to grip and push when STUCK .

    Liked On: 14-04-2023, 09:33 PM

12. 
    dannyb liked post by m101a1 On thread : 4x4 Paint job options

    Easier to grip and push when STUCK .

    Liked On: 14-04-2023, 08:32 PM

13. 
    Nasty Factory Trigger liked post by m101a1 On thread : Substituting projectiles

    Been following this for a while in the 90s early 2000 up to 2019 I have pulled 1000 approx .min x nzdf men86 projs and replaced with 135 lapua megas no resizing etc using a collet puller just...

    Liked On: 28-02-2023, 10:56 PM

14. 
    Micky Duck liked post by m101a1 On thread : Substituting projectiles

    Been following this for a while in the 90s early 2000 up to 2019 I have pulled 1000 approx .min x nzdf men86 projs and replaced with 135 lapua megas no resizing etc using a collet puller just...

    Liked On: 23-02-2023, 07:58 AM

15. 
    woods223 liked post by m101a1 On thread : Substituting projectiles

    Been following this for a while in the 90s early 2000 up to 2019 I have pulled 1000 approx .min x nzdf men86 projs and replaced with 135 lapua megas no resizing etc using a collet puller just...

    Liked On: 23-02-2023, 07:26 AM

Page 13 of 26 First 1234567891011121314151617181920212223242526 Last

• Jump to page: