Magnetite
Member

114 Likes

Page 8 of 8 First 12345678

• Jump to page:

1. 
   Magnetite liked post by Marty Henry On thread : Split shoulders

   Ook please pass me that banana

   Liked On: 09-11-2020, 05:39 PM

2. 
   Magnetite liked post by rupert On thread : Split shoulders

   The brass is corroded and/or brittle with age. Some old brass is perfectly usable after annealing to deal with the brittleness of age. Some old brass is corroded due to bad storage so much so that it...

   Liked On: 04-11-2020, 08:25 PM

3. 
   Magnetite liked post by grandpamac On thread : Notes for New and Newish Hand Loaders from an Old Fudd

   Greetings All, Post 8 Simple Ways of Setting Cartridge Overall Length and Annealing Cases. There are both high tech and low tech ways of carrying out our hand loading. These are usually matched...

   Liked On: 10-10-2020, 09:24 PM

4. 
   Magnetite liked post by ebf On thread : Primer testing methods

   Couple years back Winchester primers had some quality control issues. Lot of people ended up with gas cut bolt faces. Use them at your peril.

   Liked On: 11-09-2020, 01:50 PM

5. 
   Magnetite liked post by Flyblown On thread : 6.5mm sub 250m bullet recommendations

   Do a google search for Speer Gold Dot expansion tests. Jonny tested the 6.5 them quite thoroughly. I don’t really see the point of doing an expansion test at 10 yards though... ...

   Liked On: 06-09-2020, 05:47 PM

6. 
   Magnetite liked post by Pommy On thread : 6.5mm sub 250m bullet recommendations

   Basically one or two votes for each bullet out of the entire catalogue. Hope we managed to narrow it down for you :thumbsup:

   Liked On: 05-09-2020, 01:03 PM

7. 
   Magnetite liked post by grandpamac On thread : Preferred barrel bullet weight

   Greetings All, I think that there is one thing that we have glossed over. Our first step should be to decide what we are trying to achieve. If our load is primarily for long range shooting or is it...

   Liked On: 03-09-2020, 11:08 AM

8. 
   Magnetite liked post by grandpamac On thread : 6.5x55 SE Sanity Check

   Greetings Magnetite, I tried 49 and 50 grains of AR2213SC behind the 129 grain SST which gave 2,720 and 2,780 fps respectively. You may get a little more. As far as your accuracy figures go you...

   Liked On: 02-09-2020, 08:55 PM

9. 
   Magnetite liked post by grandpamac On thread : 6.5x55 SE Sanity Check

   Greetings Magnetite, Looks like your rifle gives a little more velocity than mine with your selection of components. I note that you are using a suppressor which some suggest gives more velocity so...

   Liked On: 01-09-2020, 08:17 PM

Page 8 of 8 First 12345678

• Jump to page: