Hi all. I've recently quit my job as a full time machinist to start up my own business. Bad time to start up but here it goes. I think a lot of the products we import for firearms could be made...
Liked On: 03-06-2024, 05:08 PM
Grabs comfy chair and popcorn :)
Liked On: 10-01-2024, 11:47 PM
I have a pro chrono and had some problems initially. These were due to it being too close to the muzzle blast. Moving it back to 5 metres from the muzzle fixed it. Then adding a correction to get...
Liked On: 04-11-2023, 04:35 PM
Cannons are an easy way to use hands full of powder. 230196230197
Liked On: 10-08-2023, 09:01 PM
I thought I’d share my experience with a BLR 81 Takedown .308 I’m nearly 60, but still quite good with scoped rifles, but all the rifles I have are not ideal bush stalkers, so I thought I’d change...
Liked On: 10-08-2023, 08:58 PM
You misunderstand the meaning of cocked. The firing pin is cocked no matter whether it is retained by the sear or not. The M70 and most of our modern rifles are based off the Gewehr M98 a "cock on...
Liked On: 26-07-2023, 09:50 PM
Empty chamber. Having a deer 10m in front of me and failing to shoot it, does not put me off hunting. Accidently injuring or killing myself or a loved one definitely will...
Liked On: 26-07-2023, 08:58 PM
Condolences
Liked On: 22-06-2023, 05:08 PM
Best solution, don't by a crapple iphone.
Liked On: 14-04-2023, 10:45 PM
I do recall though that my Sako a7 rough tech was 30 inch pounds with a plastic trigger guard...I'd say if you wanted to experiment, start at the Tikka recommended and work down looser. Just my 2...
Liked On: 04-04-2023, 09:16 PM
My Tikka manual says 44 inch pound for plastic trigger guard and 62 inch pounds for metal trigger guard. Say it with me INCH pounds :D 220278
Liked On: 04-04-2023, 07:51 PM
point and shoot.....job done.
Liked On: 04-04-2023, 05:47 PM
I would look up what B&C say. I put a B&C stock on a mates T3 last year and it transformed it. They still need a skim bed on the Ali bedding block. So relieve the Ali block and wrap tape around the...
Liked On: 04-04-2023, 01:14 PM
I'd use tikkas factory specs and check for accuracy as your still screwing against their less than ideal bottom metal which fails if over torqued, unless you have swapped out the triggergaurd/btm...
Liked On: 04-04-2023, 01:13 PM
This is what Weatherby advise for there stocks, this is what I use for my mk v composite stock with bedding block. They list different values for wood, carbon, composite and synthetic, I imagine...
Liked On: 03-04-2023, 09:22 PM