308s aren't picky. Grab a box of Sako, Federal, Remington, Norma, Hornady, Winchester with 150gn projectiles. I doubt you'll be able to tell the difference between any of them in accuracy nor...
Liked On: 02-08-2024, 11:15 PM
Doesn't sound like an ammunition problem. If the bolt lifts all the way up, the case should come out freely after this. Lifting the bolt up all the way should engage the primary extraction and...
Liked On: 30-07-2024, 04:31 PM
Very good. Shot three reds in a river valley just on dusk a few months ago. Around 290m for the first two and 120m for the last one. First one was an onside front of shoulder shot, quartering...
Liked On: 29-07-2024, 08:44 PM
I feel like I've cracked the massive potential in goat meat. I simply mince it. There's only so many goat curries one wants to eat and it's a difficult meat to prevent drying out. It makes an...
Liked On: 29-07-2024, 10:08 AM
It's a damp cold...
Liked On: 26-07-2024, 08:04 AM
Check your magazine spring isn't installed around the wrong way. This typically makes the rear stick up to far and the nose to dive and jam though so I doubt this also quite likely it's not even...
Liked On: 23-07-2024, 07:02 PM
Very good. Shot three reds in a river valley just on dusk a few months ago. Around 290m for the first two and 120m for the last one. First one was an onside front of shoulder shot, quartering...
Liked On: 22-07-2024, 08:56 PM
Check your magazine spring isn't installed around the wrong way. This typically makes the rear stick up to far and the nose to dive and jam though so I doubt this also quite likely it's not even...
Liked On: 22-07-2024, 08:00 PM
Very good. Shot three reds in a river valley just on dusk a few months ago. Around 290m for the first two and 120m for the last one. First one was an onside front of shoulder shot, quartering...
Liked On: 22-07-2024, 01:42 PM
Very good. Shot three reds in a river valley just on dusk a few months ago. Around 290m for the first two and 120m for the last one. First one was an onside front of shoulder shot, quartering...
Liked On: 22-07-2024, 12:45 PM
First thing to eliminate with POI shifts is scope and scope mounts. Take scope off, re tighten everything, reinstall and sight in. Until this is eliminated as a potential source of variation I...
Liked On: 16-07-2024, 12:36 PM
Plenty in the link but replicated here: 254564 254565
Liked On: 12-07-2024, 11:34 AM
Anyone tried swaging .224 bullets down to .223? Not much of a difference and I anticipate with a bit of case lube through a lead projectile type sizing die with good surface finish they'd come out...
Liked On: 12-07-2024, 10:47 AM
Plenty in the link but replicated here: 254564 254565
Liked On: 11-07-2024, 08:55 PM
Hi all, over the next year or two, I'm going to be selling off the rifles I don't shoot and focusing on older projects and target or hunting rifles I do intend to use regularly. I essentially want...
Liked On: 11-07-2024, 06:17 PM