At least you can take a caravan to them!
Liked On: 19-07-2022, 05:49 PM
https://www.nzhuntingandshooting.co.nz/f65/reload-data-internet-84944/ Different section. ADI only lists data for trail boss up to 240grn (Starting of 6.0gr and max of 7.3gr). Might just have...
Liked On: 19-07-2022, 05:41 PM
I really like the 2 stage too. In particular the Savage trigger when its adjusted down. Its good for my mental process - take up the blade pressure, exhale and think "boy, now you're for it", and...
Liked On: 19-07-2022, 03:28 PM
Absolutely, if I can I'll replace with a 2 stage trigger. I feel that I'm in much better control. Sent from my SM-A530F using Tapatalk
Liked On: 19-07-2022, 03:28 PM
all theNot in my .300 BLK, I did use a little Dacron in .308 but not really sure if I needed to all the Gurus at the time recommended it but a lot of what was SOP back then turned out to be BS, ...
Liked On: 19-07-2022, 02:34 PM
If you can get your hands on some old ICI Nobel 78 Shotgun Powder pm me..I've done a lot of work with it including with 303 for velocities of 1200 to 1800fps with cast bullets. 1600fps is a sweetspot...
Liked On: 19-07-2022, 02:34 PM
As per Grandpamacs post above sloppy headpacing and generous chamber dimensions could be part of the problem hence my asking for new vs fired shoulder lenghts. With the abundance of old military...
Liked On: 19-07-2022, 02:31 PM
Greetings again all, I could have been clearer in my earlier post. The early head separations in belted cases can be as much a rifle problem as a case problem. The belt recess in some belted...
Liked On: 19-07-2022, 02:29 PM
I treated reloading my 7mmRM the same way I load unbelted cases. Normally neck size but when needed bump the shoulder back just enough to chamber with a slight pressure when closing the bolt. Not...
Liked On: 19-07-2022, 02:29 PM
I have been commissioned to make a couple of kitchen names. Firstly is a Nakari, stainless Damascus, G10 and purple/ white Arylic handles. 201712
Liked On: 19-07-2022, 02:25 PM
I bought some knives in Sweden. CG m96 bayonet, CZ bayonet and a Puma " White Hunter" which is a knife I have long fancied. The Puma was produced before 1964 because it dosnt have a serial number on...
Liked On: 19-07-2022, 02:25 PM
Greetings Nathan F, This is exactly what I do for 90% of my loads although I use the Hodgdons site which presents the same data plus other powders as well. For the 50BMG there is no data for Trail...
Liked On: 19-07-2022, 02:23 PM
201711 From Hodgdons Grandpamac.
Liked On: 19-07-2022, 02:22 PM
these are made from 308 cases swagged up filled with lead its a 7 stage process very slow going but shoot very well
Liked On: 19-07-2022, 02:21 PM
do they wack a fresh primer in for a short rocket phase?
Liked On: 19-07-2022, 02:21 PM