if you have a gunsmith reasonably local, it may be worth asking them if they can do a trigger job to lighten the trigger pull ? don't get me wrong the Timney is good but it could be worth asking at...
Liked On: 29-05-2023, 01:56 PM
MOA trigger is substantially different MD. One way to get better adjustment is to remove std. spring with one of a slightly lighter gauge but also a bit longer. You get a better adjustment range...
Liked On: 29-05-2023, 01:56 PM
Don’t need trigger gauge. Just grab say an empty 1 litre milk container, add 1 litre of water = 1 kg or 2.2 pounds plus frig all weight of container. Bit of string tied around container neck and...
Liked On: 29-05-2023, 01:55 PM
No. 308win last night. We were targeting a mob of pigs that have been running riot in a friends paddocks so it was a take no prisoners mission. The pigs never showed so he was a consolation prize.
Liked On: 29-05-2023, 11:15 AM
Quality Nelson genetics.
Liked On: 29-05-2023, 11:10 AM
My muntjac on the 30day dry out below scoring 224346
Liked On: 29-05-2023, 11:07 AM
Thats a trophy white tail,well done.
Liked On: 29-05-2023, 11:07 AM
224084224085
Liked On: 29-05-2023, 11:07 AM
I have a Model 7 that only tolerates loads .5 grain less than my Tikka at the same 2.3" length. It seems to have a tight chamber. I think that its unlikely that you could get enough 2206H into a...
Liked On: 29-05-2023, 11:05 AM
That's one cute schnozzle :D
Liked On: 29-05-2023, 10:59 AM
Back in the day we had similar welfare calls via radio from the back country out to the front on Bluff / Muzzle stations. Later in life as a linesman I even went on a tuning trip to Molesworth where...
Liked On: 29-05-2023, 10:59 AM
Not unusual, the engine is out of the Nissan light truck line so built a lot heavier than automotive light vehicle engines. It runs a lot lighter loaded than the equivalent car engine, with heavier...
Liked On: 29-05-2023, 10:57 AM
The ks getting up there now and purring along. 225226
Liked On: 29-05-2023, 10:57 AM
What happened to work up to maximum powder charges, We now start at maximum and see what happens, A lot depends on the bullet design the bearing surface is quite different between bullets of the...
Liked On: 29-05-2023, 10:55 AM
Well peoples, as an add on to the thread...""Reloading in 1880's"" & ""Case forming for obsolete cartridges"" on here I thought that a thread dealing with Berdan primed to Boxer primed conversion...
Liked On: 28-05-2023, 10:30 PM