One point, everyone seems to shoot ladder testing at the same aiming mark with the results being on a vertical plane. There is no reason at all why the test cannot be done horizontally using a string...
Liked On: 30-10-2020, 01:20 PM
When setting my C.O.A.L. I jammed and measured it to be 3.366”. Backed it off to 3.350” for the loads
Liked On: 30-10-2020, 01:17 PM
Shoot them over a chrony. On many occasions with the start of load development I have ceased firing a load after only a couple of shots when the velocity wasn't what I was expecting (ie too low). ...
Liked On: 30-10-2020, 01:17 PM
Spend the morning working up some new match loads with some new bullets for the desert tech bullpup in 6.5x47 Lapua. I have only been using the barrel for hunting but decided to get back into a bit...
Liked On: 30-10-2020, 07:23 AM
Can run up to 2900fps with the 130gr class and RL16 in a 24" Trueflite. Backing them off to about 2750- 2800 tomorrow to test a lower node with 2208. Had a brain fart this morning and used my 123gr...
Liked On: 30-10-2020, 07:23 AM
If you have seated the projectiles in deeper then there will be more jump to the lands. You may need to adjust the seating die further. I generally raise the ram on the press and screw die till it...
Liked On: 29-10-2020, 10:50 PM
Firstly, you have to seat your projectiles to fit the magazine, otherwise you've got a single shot firearm. Its that simple Secondly, if your bolt wont close you need make sure the case is trimmed...
Liked On: 29-10-2020, 10:49 PM
You can remove the bullets safely and without damage by using a hornady bullet pulker fitted with appropriate colket for your calibre. Did you trim your brass to the correct kength as specified in...
Liked On: 29-10-2020, 10:48 PM
So I guess my conclusion is doesn't matter which one you have the specs are to close to worry about changing. The Poooseventy definitely has a factory advantage with the better ballistics Vs price...
Liked On: 29-10-2020, 10:42 PM
Sponsors were providing factory rifles and factory ammo. The crew then had to work out what was more effective in that setup for a short rifle. Turned out the 270 beat the others hence they used it.
Liked On: 29-10-2020, 10:37 PM
Greg duley ran the numbers and I think to 300m the 270 bushpig outperformed the 308 and 7mm08. Fusion and federal trophy bonded tips are what they run. Need a good suppressor for a short 270 though
Liked On: 29-10-2020, 10:36 PM
The shorter you go the larger the holes in the Barrel. But note recoil and noise increase. 308 Family case size , 30, 338, 358 will all make Big holes and the best use of a short barrel. of course...
Liked On: 29-10-2020, 10:35 PM
nothing at all wrong with poohseventy.... Duleys have been using one as bush rifle as sponsers wanted factory rifle and ammo last season...they ran the numbers and poohseventy WON HANDS DOWN........
Liked On: 29-10-2020, 10:34 PM
A little rem mod 7 or mohawk would be ideal and no modification needed. Thompson Conteder in 308 is compact and very accurate with rem 150 corlokts and very cheap.
Liked On: 29-10-2020, 10:32 PM
Hunting programs have to apply and pay for a concession to film on public land because they are making an income from their filming, much like a guiding company has to pay for a concession. General...
Liked On: 29-10-2020, 05:20 PM