R93 was released in 1993. It’s old. R8 2008. It’s new(er). R93 is basically discontinued. Unless you can get it for a great price or have access to more barrels etc it’s going to be tough to move...
Liked On: 20-03-2020, 12:21 AM
Make sure you work up - both these powders look excellent (case full and 100% burn) Vihtivouri N560 Cartridge : 6.5-06 A-Square Bullet : .264, 140, Sierra SPBT 1730...
Liked On: 19-03-2020, 12:54 AM
Had this on a mate’s Sauer 202 with a NF SHV. I put a piece of electrical tape on the bottom of the front ring and the top of the rear ring and it lifted the scope 1mm or so. He’s shot a hat full of...
Liked On: 19-03-2020, 12:39 AM
Four hundred yards is still a bloody long hunting shot.
Liked On: 19-03-2020, 12:37 AM
Freezing blows the cells open a bit which is kinda what you do when you hang it. It starts decomposing ( doesn't sound very good when ya say it like that :) I did a sheep a couple of months ago...
Liked On: 18-03-2020, 06:40 PM
you can age it after you thaw it too...just leave it in fridge for 2-3 days...I put a pudding bown upsidedown inside a large SS mixing bowl and sit venni on this...that way any blood that drains out...
Liked On: 18-03-2020, 06:39 PM
People eat venison? I thought you just left it on the ground after you posed for the pictures? Sent from my iPhone using Tapatalk
Liked On: 18-03-2020, 06:39 PM
The test is when it's time to cook and eat it, if back steaks are tuff (not from poor overcooking) then mince the rest for burgers/sausages or cuts for slow cooker or just suck it up and chew a lot...
Liked On: 18-03-2020, 06:38 PM
Try a shim for a start. Easy fix at virtually no cost
Liked On: 18-03-2020, 05:15 PM
There is probably still more than enough meat for strength but the problem is that the uneven barrel wall thickness will cause the barrel to shift its POI as it heats up. Gunsmithing 101 really,...
Liked On: 18-03-2020, 05:14 PM
Pommy - I never realised you were interested in fishing?!?
Liked On: 18-03-2020, 01:50 PM
I'm really starting to feel like apologising for the sh!tfest I created here how many years ago!:XD:
Liked On: 18-03-2020, 01:49 PM
Yes. Get higher rings, or try shimming with a cut up coke can.
Liked On: 18-03-2020, 01:43 PM
I’m new to hand loading and this is the first larger caliber round I’ve loaded. I’m using AR2209 46gr, 162gr ELD M, through a 22in Blaser 7mm08. During my drop validation in near perfect conditions...
Liked On: 17-03-2020, 10:37 PM
Hard extraction/stiff bolt lift without any conventional pressure signs is often caused by brass not being sized enough by your dies, usually at the base. Often the first couple of firings on new...
Liked On: 17-03-2020, 01:40 PM