About NAKED_GOOSE

Basic Information


Age
21
About NAKED_GOOSE
Location:
West Coast
Interests:
Guiatrs. Motorcycles, two strokes

Statistics


Total Posts
Total Posts
190
Posts Per Day
0.23
General Information
Last Activity
Today 08:11 AM
Join Date
09-12-2022
Referrals
0

345 Likes

  1. NAKED_GOOSE
    NAKED_GOOSE liked post by 11mms On thread : DIY Fibre wads?
    Just a quick drain-dump of what I think I know: Old wool felt jackets and hats can be found at op-shops and normally come 1/8" - 3/8" think And a good coat will last quite a while! My lube is a...
    Liked On: 27-10-2023, 09:34 AM
  2. NAKED_GOOSE
    NAKED_GOOSE liked post by akaroa1 On thread : DIY Fibre wads?
    From memory roll width was 900mm and minimum cut length was 500mm A good size chunk that will make many hundred wads. I use the 9.5mm grey for all my felt wad needs With a good punch, decent...
    Liked On: 26-10-2023, 04:30 PM
  3. NAKED_GOOSE
    NAKED_GOOSE liked post by Tedz50 On thread : DIY Fibre wads?
    I would go in and pick through their scrap bin and buy offcuts,but our locals were very helpful. Any punch works as long as it is sharp and end grain soft wood for a backing. 236135 236137...
    Liked On: 26-10-2023, 12:03 PM
  4. NAKED_GOOSE
    NAKED_GOOSE liked post by akaroa1 On thread : DIY Fibre wads?
    The A and B grade is the same density just prettier For punches just buy good individual ones from and engineering supplier Don't waste your time on cheap sets and crap imports The...
    Liked On: 26-10-2023, 11:55 AM
  5. NAKED_GOOSE
    NAKED_GOOSE liked post by Tedz50 On thread : DIY Fibre wads?
    https://www.shuk.co.nz/ They have wool felt in various thicknesses as well. 236077 236078 236079
    Liked On: 26-10-2023, 07:45 AM
  6. NAKED_GOOSE
    NAKED_GOOSE liked post by rupert On thread : DIY Fibre wads?
    I tried a simple home made hit it with a club hammer type punch for 20ga wads using Pinex wallboard which is about 10mm thick. It seemed to work a bit but the edge of the punch rolled over after a...
    Liked On: 24-10-2023, 04:26 PM
  7. NAKED_GOOSE
    NAKED_GOOSE liked post by Marty Henry On thread : DIY Fibre wads?
    Card, greased pinex then shot is my version the grease sort of glues the wad together and makes it much easier to load. Pin in the wad and a quick dip in beeswax /lard 1:1 then allow to harden .
    Liked On: 24-10-2023, 04:20 PM
  8. NAKED_GOOSE
    NAKED_GOOSE liked post by zimmer On thread : DIY Fibre wads?
    I think 25 mm is the old thick Pinex, not the Michelangelo version of ceiling tiles. To make the holesaw into a knife rather than a messy ripping saw. Effectively a rotary wadcutter like my mate's.
    Liked On: 24-10-2023, 04:00 PM
  9. NAKED_GOOSE
    NAKED_GOOSE liked post by zimmer On thread : DIY Fibre wads?
    The cutter I used belonging to a mate was specially made to cut 12g wads. Back then those sorts of things were available. It had a sprung centre plunger that popped the wad out once cut. Even if...
    Liked On: 24-10-2023, 03:50 PM
  10. NAKED_GOOSE
    NAKED_GOOSE liked post by zimmer On thread : DIY Fibre wads?
    I used to use ceiling Pinex. Can you still get Pinex though? Mate had a special 12g cutter that you put in a drill press for making wads. IIRC I had one thin stiff overpowder wad (cut with correct...
    Liked On: 24-10-2023, 03:30 PM
  11. NAKED_GOOSE
    NAKED_GOOSE liked post by tac a1 On thread : Useing the firearms register
    So, just rang the registry number as I cant get the bloody thing to work. Wont accept password. Spoke to a really nice Indian lady who was immensely helpful. All guns registered in 15 minutes....
    Liked On: 20-10-2023, 03:10 PM
  12. NAKED_GOOSE
    NAKED_GOOSE liked post by ishoot10s On thread : Useing the firearms register
    My god. The database just full of rubbish already, the chumps. When I tried to find a match for an old single barrel 12 ga Champion, I get a choice of a single shot, or an 8 shot! Since when did Iver...
    Liked On: 20-10-2023, 02:29 PM
  13. NAKED_GOOSE
    NAKED_GOOSE liked post by blip On thread : Useing the firearms register
    I wonder would fuckedifiknow would pass as a serial no.:)
    Liked On: 20-10-2023, 02:08 PM
  14. NAKED_GOOSE
    NAKED_GOOSE liked post by Flyblown On thread : Raising a magpie chick - any tips
    Dog food - dog roll I assume? Talk to it - ok. I already talk to myself a lot so talking to a bird is probably a step in the right direction. It will possibly cure you of shooting magpies -...
    Liked On: 20-10-2023, 11:29 AM
  15. NAKED_GOOSE
    NAKED_GOOSE liked post by Micky Duck On thread : scofemupdelishimo duck balls
    The fruit is for......scale lol235611
    Liked On: 19-10-2023, 11:08 AM

20-02-2025


19-02-2025


16-09-2024


03-09-2024


10-11-2023


01-11-2023


27-10-2023


26-10-2023


24-10-2023


No results to display...
Welcome to NZ Hunting and Shooting Forums! We see you're new here, or arn't logged in. Create an account, and Login for full access including our FREE BUY and SELL section Register NOW!!