No.3
Member

715 Likes

Page 39 of 48 First ... 252627282930313233343536373839404142434445464748 Last

• Jump to page:

1. 
   No.3 liked post by PaulNZ On thread : 22lr Resizing/Hollow Pointing Tool

   Just a variation on a theme, but after seeing your tests I think I've settled on the punch shape for my setup as well. I was using a 60deg lathe centre, but am now using a simple 28deg cone with a...

   Liked On: 30-01-2023, 02:59 PM

2. 
   No.3 liked post by csmiffy On thread : Front on shots at Deer.

   It's funny how everyone is agreeing with a post i made a while back. Albeit from very limited experience I suggested the same thing but had a couple say I was a little misguided. Seems to be a lot...

   Liked On: 26-01-2023, 05:33 PM

3. 
   No.3 liked post by csmiffy On thread : Helicopter pilot gratuity

   7mmwsm nope. It will only be an excuse for employers to not raise wages. Dont go there. Way to many assholes out there that will do just that

   Liked On: 26-01-2023, 05:30 PM

4. 
   No.3 liked post by Boner On thread : Great deal on tyres

   For forum members in Dunedin area. Just go 2 wrangler duratracs and a wheel alignment from Challenge garage on Frederick St for just over $800. I paid $510 a corner for my other vehicle less than 6...

   Liked On: 26-01-2023, 01:43 PM

5. 
   No.3 liked post by Moa Hunter On thread : Front on shots at Deer.

   I hate front on shots for the reasons given above and that they dont give the paralyising stun up the ribs to the spinal cord that a side on shot does. The solution for me now is to aim at the neck...

   Liked On: 26-01-2023, 01:00 PM

6. 
   No.3 liked post by viper On thread : What breed of deer are these ?

   :D , classic. Goes to Bali, lovely beach's, ton of bars and restaurants. Warm sea , culture but "NO" , in typical NZHS member behavior Nathan F is in the bush stalking fucking deer.

   Liked On: 26-01-2023, 12:55 PM

7. 
   No.3 liked post by Moa Hunter On thread : Leupold Turret Help

   Cut a piece of car tyre tube to a shape that it covers over both turrets and down the sides when cable tied around the scope tube ahead of the turrets. If cut roughly to size it can be shaped after...

   Liked On: 22-01-2023, 12:46 AM

8. 
   No.3 liked post by Oldbloke On thread : Relaoders Supplies

   My guess, Ukraine.

   Liked On: 19-01-2023, 03:15 PM

9. 
   No.3 liked post by Moutere On thread : Broadhead Sharpening

   If the OP means fixed blade broadheads, fine wet and dry stuck down on a piece of thick glass works good as another cost effective option.

   Liked On: 19-01-2023, 12:11 PM

10. 
    No.3 liked post by Marty Henry On thread : Old Single shot rifle

    grandpamac Under the top handguard there will be another S. That's the full sold out of service mark, 2 broad arrows nose to nose with an S either side. The back numbers go up to 4000, so yours is a...

    Liked On: 19-01-2023, 08:49 AM

11. 
    No.3 liked post by jakewire On thread : Redundant Calibres

    Everybody knows the 308 was made redundant 61 years before it was designed.:)

    Liked On: 17-01-2023, 01:14 PM

12. 
    No.3 liked post by timattalon On thread : Feeling sick after reading this !

    And LFAO's lives and pastimes are in turmoil because of political ineptitude (AKA dumbshittery) so does that mean they will go less hard on us??? I doubt it.But I figured out why the Police Hierachy...

    Liked On: 17-01-2023, 11:37 AM

13. 
    No.3 liked post by csmiffy On thread : Redundant Calibres

    303-08

    Liked On: 16-01-2023, 09:49 PM

14. 
    No.3 liked post by vulcannz On thread : Feeling sick after reading this !

    That is true, I guess the police are looking at recovered firearms will close the loop in that they will able to identify where they came from. But again how easy is it to grind off a serial number....

    Liked On: 16-01-2023, 09:36 PM

15. 
    No.3 liked post by Maca49 On thread : This is F**ked

    Police are becoming experts at it:pissed off:

    Liked On: 13-01-2023, 12:51 PM

Page 39 of 48 First ... 252627282930313233343536373839404142434445464748 Last

• Jump to page: