6.2 litre 6 speed HSV here 1300 rpm at 100 kph in 6 th 9L/100 km av fuel use if driven carefully Rear end ratio selection is not a panacea How you use your throttle is
Liked On: 15-07-2022, 02:29 PM
get it welded up and new holes drilled?
Liked On: 12-07-2022, 06:20 PM
Don't forget to clean out intercooler. It will have oil in it
Liked On: 11-07-2022, 08:43 PM
Ply cut to shape as mentioned, can add synthetic carpet. The yanks have a neat system you don't see here,can flip one way out to the edge of a open tail gate or flipped back into the cargo area to...
Liked On: 10-07-2022, 11:13 PM
I cut ply to deck shape then used left over garage carpet stapled to ply..
Liked On: 10-07-2022, 11:13 PM
Screw all the the way home tight and loosen the thin lock ring behind the power ring and unscrew the bell or ocular housing out till it suits . You have unscrewed the lense body not the focus ocular...
Liked On: 09-07-2022, 06:42 PM
same as going 2 clicks too far,then back...to take out any slack in threads...engineer told me to do this some 40 years ago..that and tap turrents....so I always have n always will.
Liked On: 02-07-2022, 10:49 PM
I've got two RAV4, one diesel one gas, 2014 diesel in NZ and a 2015 gas in Canada, same spec vehicle. average between 7.5-8L a 100km in the Diesel, down to 6l on the likes of the Canterbury...
Liked On: 01-07-2022, 05:08 PM
I managed to pick up a set of Mitutoyo digi calipers at a second hand store. $40 couldn't believe it. Near brand new in the original packaging. Got to get a win every now and then.
Liked On: 29-06-2022, 06:38 PM
https://www.trailersauce.co.nz/ Some good info and plans on here
Liked On: 25-06-2022, 07:29 PM
Takes me 1 hour 20min to fill the 2000L tank at Gull, cause they permit one fill going to $200 before its: put nozzle back in slot-go get receipt enter credit card go get nozzle start filling , rinse...
Liked On: 22-06-2022, 07:10 PM
Very true, NZTA have left it way too long to address the ruling and now it'll be a huge expense to the tax payer to put it in a more workable format. There is talk & plans of alignment with NZ...
Liked On: 21-06-2022, 11:14 AM
I wouldnt rate Hardy suppressors at all. Had one on my AR. One of the fancy AR specific ones. Against a mates DPT on his 16" and my Hardy with its 20" barrel. The Hardy was not what I'd...
Liked On: 18-06-2022, 08:00 PM
My Gunworks suppressor was made in 1997. Still works absolutely fine. A bit heavier than most, but a bit quieter than most, as lightness and shortness became a bit of a fad post 2010. I was...
Liked On: 18-06-2022, 07:59 PM
My old Lee Enfield has a 10 shot mag; I usually put 3 or 4 into it once I realised that the deer weren't yelling "Banzai" when they left cover of the bush or trying to encircle my position in a...
Liked On: 18-06-2022, 07:55 PM