Pommy
Member

1379 Likes

Page 2 of 92 First 1234567891011121314151652 ... Last

• Jump to page:

1. 
   Nasty Factory Trigger liked post by Pommy On thread : Sub - X load - Case filler needed?

   Whatever case filler you use will end up gumming up your suppressor. You could try a powder like Titegroup. Pitiful case fill, but supposedly position insensitive enough to get away with it. Fast...

   Liked On: 09-02-2025, 11:07 AM

2. 
   caberslash liked post by Pommy On thread : Match bullets for hunting deer

   3. Depends, what is the bullet. On HPBT bullets, the hollow point part isn't necessarily a design feature that's there to promote expansion, it's an artifact from the way the jackets are drawn up...

   Liked On: 08-02-2025, 07:50 AM

3. 
   inglishill liked post by Pommy On thread : Match bullets for hunting deer

   3. Depends, what is the bullet. On HPBT bullets, the hollow point part isn't necessarily a design feature that's there to promote expansion, it's an artifact from the way the jackets are drawn up...

   Liked On: 07-02-2025, 02:05 AM

4. 
   6.5 CRD liked post by Pommy On thread : 7mm08 loads and a short barrel

   267734 GRT suggests 40gr should be your limit at 2543fps. I'd just load them to 2500fps and be happy.

   Liked On: 28-01-2025, 12:33 PM

5. 
   Rn-85 liked post by Pommy On thread : .22lr budget - will I regret buying cheap?

   Whilst you can shoot small groups with inexpensive rifles and optics, IMO it's a roll of the dice buying a JW15. Most of the older ones are decent enough. Some of the newer ones are rather poor. I...

   Liked On: 20-01-2025, 02:55 PM

6. 
   tikka liked post by Pommy On thread : Impact joules and ethics

   I'm shooting a 223AI with an 88gr ELD-M. It drops below 1000ft/lbs at ~200m. But the bullet on paper should still expand and produce adequate wounding to kill an animal cleanly out to ~600m... ...

   Liked On: 19-01-2025, 10:49 AM

7. 
   caberslash liked post by Pommy On thread : Impact joules and ethics

   I'm shooting a 223AI with an 88gr ELD-M. It drops below 1000ft/lbs at ~200m. But the bullet on paper should still expand and produce adequate wounding to kill an animal cleanly out to ~600m... ...

   Liked On: 17-01-2025, 02:22 AM

8. 
   Dicko liked post by Pommy On thread : .223 projectile ponderings

   Stability. Those 75's can be pretty borderline in 1:8's. Some rifles stabilise them but not all. I'd try a few before buying 500. On the box, Hornady say a 1:7.5 twist is needed.

   Liked On: 15-01-2025, 10:40 PM

9. 
   woods223 liked post by Pommy On thread : Impact joules and ethics

   I'm shooting a 223AI with an 88gr ELD-M. It drops below 1000ft/lbs at ~200m. But the bullet on paper should still expand and produce adequate wounding to kill an animal cleanly out to ~600m... ...

   Liked On: 15-01-2025, 07:00 PM

10. 
    HNTMAD liked post by Pommy On thread : Impact joules and ethics

    1. 580m. 2. Wallaby. 3. Upper chest. 4. I said "adequate wounding to kill an animal cleanly". Which it did. Also multiple deer and pigs at between 250m and 500m with that and other 22 cals. All...

    Liked On: 15-01-2025, 05:53 PM

11. 
    Shearer liked post by Pommy On thread : Impact joules and ethics

    I'm shooting a 223AI with an 88gr ELD-M. It drops below 1000ft/lbs at ~200m. But the bullet on paper should still expand and produce adequate wounding to kill an animal cleanly out to ~600m... ...

    Liked On: 15-01-2025, 04:58 PM

12. 
    20 Bore liked post by Pommy On thread : Maker Projectiles

    TeRei, they don't need to be driven as fast to open out. When they do open, you have petals / blades rather than a plain mushroom. Like being hit by a blender at mach 3. There's two versions......

    Liked On: 14-01-2025, 07:44 PM

13. 
    Growlybear liked post by Pommy On thread : CCI .22 LR Suppressor 45gr Hollow Point

    Yep. I've used a lot of it. Section22 shoots at Sparrowhawk out to 400m and for hunting on rabbits, hares, possums, and roos. It hits harder than the 40gr stuff. Does about 1000fps from rifle...

    Liked On: 14-01-2025, 05:47 PM

14. 
    Roarless20 liked post by Pommy On thread : Maker Projectiles

    Assume G1. And also assume that they are approximate (like Targex for example), as I can't imagine Maker have a means of testing that's as sophisticated as what the likes of Hornady or Berger are...

    Liked On: 14-01-2025, 02:34 PM

15. 
    dannyb liked post by Pommy On thread : Maker Projectiles

    Assume G1. And also assume that they are approximate (like Targex for example), as I can't imagine Maker have a means of testing that's as sophisticated as what the likes of Hornady or Berger are...

    Liked On: 14-01-2025, 02:12 PM

Page 2 of 92 First 1234567891011121314151652 ... Last

• Jump to page: