Mitch Maxberry did the most spectacular job on my last barrel with a 14x1 for a T2. There is almost no off-axis movement after just 2 turns of engagement yet the barest thread contact friction...
Liked On: 19-02-2017, 04:41 PM
Checking the calibration of the scope dials can be done very accurately, so why not eliminate this variable completely? Something similar to the jig and measuring stick pictured in the thread...
Liked On: 01-02-2017, 07:15 AM
Not sure I follow Andy? Perhaps you or Gibo would be able to advise how MV and BC could be adjusted from observed trajectory data if the scope calibration is not known? The only way I can think of...
Liked On: 01-02-2017, 07:14 AM
I have used a 1.5-5x20 Vari-X 3 continuously on the bush rifle for 25 years. 1.5x is great for quick target acquisition. Longer range, out at say 300m, is hampered somewhat in my view by the course...
Liked On: 24-01-2017, 04:05 PM
I would suggest that if intending to load the 162gr for 60kPSI peak or over - as seems to be the practice in the endless quest to equal 7mmRM performance - then 2213sc may be the limit for burn rate...
Liked On: 19-01-2017, 10:55 AM
To save modifying an existing powder on-screen each time you could consider updating the powder data file with an extra line for this powder and additional lines for any new powders you may care to...
Liked On: 18-01-2017, 03:21 PM
To save modifying an existing powder on-screen each time you could consider updating the powder data file with an extra line for this powder and additional lines for any new powders you may care to...
Liked On: 18-01-2017, 02:36 PM
To save modifying an existing powder on-screen each time you could consider updating the powder data file with an extra line for this powder and additional lines for any new powders you may care to...
Liked On: 18-01-2017, 11:04 AM
Further to the previous post and some more info specifically for Feebz' Forbes in case he is interested, putting his results into QuickLoad along with the other powders being mentioned....
Liked On: 15-01-2017, 07:28 PM
Further to the previous post and some more info specifically for Feebz' Forbes in case he is interested, putting his results into QuickLoad along with the other powders being mentioned....
Liked On: 15-01-2017, 07:14 PM
I would suggest that if intending to load the 162gr for 60kPSI peak or over - as seems to be the practice in the endless quest to equal 7mmRM performance - then 2213sc may be the limit for burn rate...
Liked On: 15-01-2017, 09:17 AM
When I was looking to buy my first centrefire, and knowing nothing about hunting, I figured it was best to use the “Wisdom of Crowds” to decide what I should purchase. To this end I spent months...
Liked On: 03-01-2017, 05:55 PM
I haven't read the article but I can see the Creedmoor rating well if recoil was a heavily weighted consideration. I view the smaller 6.5s as sitting at a sweet spot for effectiveness on medium...
Liked On: 03-01-2017, 03:49 PM
I haven't read the article but I can see the Creedmoor rating well if recoil was a heavily weighted consideration. I view the smaller 6.5s as sitting at a sweet spot for effectiveness on medium...
Liked On: 03-01-2017, 11:53 AM
Friwi makes a good point earlier, one that has been aired in other threads, but is worth repeating because few give it the consideration it deserves: if precision dramatically improves when the felt...
Liked On: 14-12-2016, 08:27 PM