Rated M for Magnum
Member

427 Likes

Page 26 of 29 First ... 121314151617181920212223242526272829 Last

• Jump to page:

1. 
   Rated M for Magnum liked post by Ryan_Songhurst On thread : Hi-Tec / Ken Henderson Stocks

   This is my 27 Nosler at 100yds... big magnum cartridge. Its on a aluminium bedding block, which obviously works well, shoots ok.. 106037 106038

   Liked On: 27-01-2020, 10:11 PM

2. 
   Rated M for Magnum liked post by Coote On thread : Reloading Mysteries

   I managed to get to the range today to test some new reloads for my Bergara .357 magnum. I've had a bit of reloading experience, but up until recently I've just followed common recipes. However,...

   Liked On: 18-01-2020, 02:13 AM

3. 
   Rated M for Magnum liked post by Tucky12 On thread : 7mm rem mag reloading

   Cheers for all the advice guys. Have gone with ar 2225 with federal large magnum primers Norma brass and 162 grain eldx. Will let yas know how I get on when I get the chance

   Liked On: 18-01-2020, 01:55 AM

4. 
   Rated M for Magnum liked post by Micky Duck On thread : Case Sizing Dramas

   sooner or later...you will not quite put it on right and case will get stuck in dies...requireing MAJOR force etc to remove it.....

   Liked On: 17-01-2020, 10:27 PM

5. 
   Rated M for Magnum liked post by zimmer On thread : Case Sizing Dramas

   Yep, the one and only time I got a case stuck in a die was trying snake oil water based spray lube for full length sizing. Out it went! Lee lube is also water based I believe. Why would you want...

   Liked On: 17-01-2020, 10:27 PM

6. 
   Rated M for Magnum liked post by 57jl On thread : Case Sizing Dramas

   if all else fails fill the size die with trail boss lite it up, then put it in the dishwasher then try imperial sizing wax it,s neva let me down even stoped the misses complaining once I started...

   Liked On: 17-01-2020, 10:26 PM

7. 
   Rated M for Magnum liked post by chainsaw On thread : 7mm rem mag reloading

   i found 2225 or RL25 best (better speed and grps than 2217) in REM700 7mmRM with 150 -160 gn pills

   Liked On: 16-01-2020, 06:30 PM

8. 
   Rated M for Magnum liked post by Edunn On thread : 708-X Bolt 16 inch is slow

   Right, so I didn't do anything to bedding (other than check screws etc were tight). But I did test out a couple of different seating depths. Found that seated out a little bit further the 139...

   Liked On: 14-01-2020, 03:28 PM

9. 
   Rated M for Magnum liked post by wayno On thread : 6.5x55ai light loads

   Anything pushed hard will wear out faster its just physics. Your barrel is your cheapest consumable , you will have spent more on powder/projectiles brass by the time your barrel is toast. and a 6.5...

   Liked On: 04-01-2020, 10:59 PM

10. 
    Rated M for Magnum liked post by johnd On thread : 6.5x55ai light loads

    did some one say '06 AI

    Liked On: 04-01-2020, 10:59 PM

11. 
    Rated M for Magnum liked post by Chilli_Dog On thread : Jw15 modifications

    Nothing particularly special here, after collecting my 22 that had been in Dads gun safe for many years it suddenly felt very short and not particularly comfortable to hold. First step was stripping...

    Liked On: 01-12-2019, 01:47 PM

12. 
    Rated M for Magnum liked post by dannyb On thread : Bergara 308 single shot load development

    Well I got some AR2206H from gunworks last week and set about loading up a new ladder 7 lots of 2 going up in .5gn increments 124556 As you can see I could get much more speed but settled on...

    Liked On: 23-11-2019, 01:14 PM

13. 
    Rated M for Magnum liked post by dannyb On thread : Sako 270wsm adi 2225 and 145gn eldx

    As some of you know I've just had my sako re barreled and I've been itching to get it shooting. I tried it with my old load or rl26 and it was absolutely shite like 3 " spread at 100 yards. With...

    Liked On: 23-11-2019, 01:12 PM

14. 
    Rated M for Magnum liked post by Flyblown On thread : What little pesties did you bowl over today?

    Big PROUD moment for Dad tonight. Young lad says... Hey Dad, you going after a hare tonight? Yeah mate, bit windy for the rimfire tonight though. OK. But I think I'm ready for the centrefire...

    Liked On: 17-11-2019, 12:49 AM

15. 
    Rated M for Magnum liked post by winaa On thread : New Winchester Powder (StaBALL 6.5) and a good video on temp stability

    Winchester StaBALL 6.5, looks like and interesting powder that may knock RL-16 off its perch? https://www.youtube.com/watch?v=lcy8zqclIns

    Liked On: 05-11-2019, 06:57 AM

Page 26 of 29 First ... 121314151617181920212223242526272829 Last

• Jump to page: