Bet that Tikka was heavier too. Those 590s are nice and shoot well but are built heavy
Liked On: 24-06-2024, 12:21 PM
March F 3-24, can be had with 40 or 50mm objective, and nice clean FML reticle. Sent from my iPhone using Tapatalk
Liked On: 19-06-2024, 09:40 PM
Be ideal for teaching my old cows NOT to eat the bark off my trees. Just relies on my timing for them opening their mouth for a chew and bang! Owww! my arse hurts:o
Liked On: 19-06-2024, 08:06 PM
This works for me. Lol
Liked On: 18-06-2024, 11:50 AM
Took the K95 out today for a long range session. Spotted this hare at 656 yds. Rested over my pack with a bag under the butt. One shot, complete pass through! 252927
Liked On: 17-06-2024, 07:13 PM
It's nice being part of someones' success. Sam is a keen family member and I was very happy to source a nice T3 in .260 with a 20" Bartlein and muffler and and set it up with a scope and bipod for...
Liked On: 17-06-2024, 12:30 PM
The final family member ( project on going ) has arrived. Hunter & Sons. 10 gauge Jones Underlever Single barrel shotgun. This will likely become a 577 3" BPE Here it is with the whole family...
Liked On: 15-06-2024, 03:20 PM
Don't blame the biscuits for you being a weirdo micky.
Liked On: 10-06-2024, 01:41 PM
tie an anode to its tail
Liked On: 10-06-2024, 09:58 AM
Just wondering if anyone knows the best way to go about getting a land owners number? It's a section that has been turned back into bush and nobody lives on it. No neighbours as it borders DoC land...
Liked On: 09-06-2024, 11:13 PM
Both of our teenage boys are now driving and we needed to put them in a decent vehicle. Because they are unlikely to stay in the area for long after high school, we wanted something that we could...
Liked On: 08-06-2024, 02:07 PM
The parts are nearly ready to be glued together. I wash the knife blank with hot soapy water, rinse it with hot water, and dry it with a towel. I also ensure my hands are clean. I dry-sand both...
Liked On: 05-06-2024, 09:37 PM
This one should be relevant, how to get consistency with lightweight rifles. Who wants to lug around a heavy smokepole??? https://www.youtube.com/watch?v=MKCViW-lfus
Liked On: 05-06-2024, 08:45 AM
Cut the small hole in the inside skin and the larger clearance hole thru the outer skin and foam. Glue a sheet of Ply/fibrelite to the inner skin inside the larger hole for strength. You can pass...
Liked On: 05-06-2024, 08:38 AM
Most of you probably have a ‘one that got away’ story. Here’s a story of a stag that got the better of me. It’s a long read, but hopefully this one resonates with a few hunters who have missed out on...
Liked On: 04-06-2024, 10:32 PM